Solar Trend 03020 Fiche De Données
User manual
Full Set 20 watt item no. 03020
Distribution by Süd Solar GmbH, Max-Eyth-Str. 6, 71732 Tamm (Germany)
Copyright © Süd Solar GmbH, 2012. Subject to modifications.
www.sued-solar.de
Copyright © Süd Solar GmbH, 2012. Subject to modifications.
www.sued-solar.de
REV-3-27-07-12
1. Introduction
Dear customer. Thank you for purchasing one of our products.
This product corresponds to the applicable European directives and National regulations.
Conformity has been proven.
Relevant declarations and documents are deposited at the manufacturer.
This product corresponds to the applicable European directives and National regulations.
Conformity has been proven.
Relevant declarations and documents are deposited at the manufacturer.
2. Safety note
Failure to observe these instructions will render the warranty void.
We assume no liability for consequential damages! We will assume no liability for material damage or personal injury resulting from
inappropriate handling or non-compliance with the safety precautions. In such cases, any warranty shall be void. For safety reasons
(CE), unauthorised alterations or changes to the product are not permitted. This product is not a toy. Keep out of children's reach.
We assume no liability for consequential damages! We will assume no liability for material damage or personal injury resulting from
inappropriate handling or non-compliance with the safety precautions. In such cases, any warranty shall be void. For safety reasons
(CE), unauthorised alterations or changes to the product are not permitted. This product is not a toy. Keep out of children's reach.
3. Application, setup and connection as directed
The product is designed for outdoor use and intended for gaining solar power.
Please make sure that the polarity is correct during setup.
Please refer to the identification markings PLUS (+) and MINUS (-)!
This set (item no. 03020) is not suitable to actuate cool boxes or refrigerators.
Please make sure that the polarity is correct during setup.
Please refer to the identification markings PLUS (+) and MINUS (-)!
This set (item no. 03020) is not suitable to actuate cool boxes or refrigerators.
The following sketch illustrates the connection of all components to the charge / discharge regulator (item no. 03155):
4. Continuation initial start-up
6. Now connect the battery connection cable to the supplied 9Ah battery. Connect the lead marked with PLUS (+) to the
POSITIVE TERMINAL (+) and the lead marked with MINUS (-) to the NEGATIVE TERMINAL (-).
7. If necessary, you use another 12V rechargeable battery with higher capacity (Ah) to allow a greater energy storage. A
rechargeable battery with 15Ah to 35Ah is recommendable.
Special solar batteries are offered under www.sued-solar.de.
8. Do not switch on the appliances (load) until the solar module has charged the 12V battery sufficiently.
4. Initial start-up
1. Carefully unpack all parts.
2. Position the solar module in a suitable place
exposed to direct sunlight. All cables must be
laid accurately and safely.
laid accurately and safely.
3. Connect the battery connection cable of the
12V battery (a 9Ah battery is included in the
delivery) to the two middle connections.
Connect the lead marked with PLUS (+) to
"B+" and the lead marked with MINUS (-) to
"B-".
delivery) to the two middle connections.
Connect the lead marked with PLUS (+) to
"B+" and the lead marked with MINUS (-) to
"B-".
4. Connect the solar module to the two left
connections. Then connect the lead marked
with PLUS (+) to "S+" and the lead marked
with MINUS (-) to "S-".
with PLUS (+) to "S+" and the lead marked
with MINUS (-) to "S-".
5. The 12V junction box for connecting electrical
appliances (loads), e.g. 12V radio or suitable
LEDs, must be connected to the two right
connections. Then connect the lead marked
with PLUS (+) to "L+" and the lead marked
with MINUS (-) to "L-".
LEDs, must be connected to the two right
connections. Then connect the lead marked
with PLUS (+) to "L+" and the lead marked
with MINUS (-) to "L-".