Grandstream HT701 HANDYTONE ATA-ROUTER HT701 Manuel D’Utilisation
Codes de produits
HT701
FIRMWARE VERSION 1.0.4.14 HT70X USER MANUAL Page 43 of 51
If voice volume is too low at the other end, user may increase the far end volume using
the Tx Gain Level parameter under the FXS Port Configuration page.
Disable Line Echo
Canceller (LEC)
Default is No.
If set to “Yes” LEC will be disabled per call base. Recommended for
FAX/Data calls.
Ring Tones
This function lets you configure ring tone cadence preferences. User has 10 choices.
The configuration, completed in Distinctive Ring Tones block in the same page, applies
to ring tones cadences configured here.
TABLE 12: HT704 FXS PORTS SETTINGS
SIP Use ID
User account information, provided by VoIP service provider (ITSP). Usually in the form
of digit similar to phone number or actually a phone number.
Authenticate ID
SIP service subscriber’s Authenticate ID used for authentication. Can be identical to or
different from SIP User ID.
Password
SIP service subscriber’s account password for HT704 to register to (SIP) servers of
ITSP.
Name
Any name to identify this specific user.
Profile ID
Select the corresponding Profile ID between Profile 1 and Profile 2.
Hunting Group
This feature enables the HT704 to register all existing FXS ports with the same phone
number. Each incoming call will be routed to first available port in Linear or Circular
mode. User may configure all ports as members of the same Hunting Group or it may
configure different port combinations for more than one Hunting Group. For example:
Ports 1, 3 and 5 are members of the same Hunting Group, the rest of the ports may
have separate numbers and may be reached independently. Any port, member of a
Hunting Group that is not registered with a SIP account, will be able to place outbound
calls using the SIP credentials of the primary Hunting Group port.
For example: Port 1, 2, and 3 are members of the same Hunting Group. Port 1 is
registered with a SIP account. Ports 2, and 3 are not registered. Ports 2 and 3 will be
able to place outbound calls using the SIP account of port 1. Select appropriate value
for Hunting Group feature. The original SIP account should be set to Active while the
group members should be set to the port number of the Active Port.
Example configuration of a Hunting group:
FXS Port #1: SIP UserID and Authenticate ID entered, Hunting group set to "Active"
FXS Port #2: SIP UserID and Authenticate ID left blank, Hunting Group set to "1"
FXS Port #3: SIP UserID and Authenticate ID left blank, Hunting Group set to "1"
FXS Port #4: SIP UserID and Authenticate ID entered, Hunting group set to "None"
Hunting Group 1 contains ports 1, 2, 3. FXS port 4 is registered but it is not added to