C&E FC-CIL6X12LED White LED Light Set FC-CIL6X12LED Fiche De Données

  

   These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1,  

D-92240 Hirschau (www.conrad.com). 

 

 All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfi lming, 
or the capture in electronic data processing systems require the prior written approval by the editor. 
Reprinting, also in part, is prohibited. 

 

 These operating instructions represent the technical status at the time of printing. Changes in         
technology and equipment reserved. 

 

•   The product does not require any maintenance, never take it apart. The LED lights are per-

manently installed; they cannot be replaced.

•   Before carrying out any cleaning, the product is to be switched off and separated from the 

mains voltage by pulling the plug-in power supply from the mains socket. 

•   The outside of the housing should only be cleaned with a clean, soft, dry cloth. Do not use 

aggressive cleaning agents or chemical solutions that could damage the housing (discolour-
ing) or impair operation. 

  Do not press too hard on the surfaces, as scratches might appear.
   Dust can easily be removed using a clean, soft brush and a vacuum cleaner.

Ꮨ



  •  The product is only to be used in closed, dry indoor locations. The product must 

not get damp or wet! There is a risk of a life-threatening electric shock!

 

•  Never use the product immediately after it has been taken from a cold room to a 

warm one. The condensation that forms might damage your unit. The wall plug 
transformer also poses a risk for a potentially fatal electric shock!

 

   Allow the product to reach room temperature, before connecting it to the power 

supply and putting it into use. This may take several hours.

 

•  Avoid the following adverse conditions at the installation location and during trans-

portation:

 

  -  Excessive humidity or damp

 

  -  Extreme cold or heat, direct sunlight, proximity to heaters

 

  -  Dust or fl ammable gases, fumes or solvents

 

  -  Strong vibrations, impacts or blows,

 

  -   Strong magnetic fi elds such as those found in the vicinity of machinery or loud-

speakers

 

•  Any maintenance or repair work may only be performed by an authorised repair 

shop.

 

•   When setting up the product, ensure that the cables are neither bent nor squeezed.

 

  Install all cables in such a way that nobody may trip over them.

   Dispose of an unserviceable product in accordance with the relevant statutory regu-

lations.

a) LED strip
Operating voltage ......................12 V/DC
Light source ...............................12 LED per LED strip 
Colour temperature ....................Warm white
Protection class .........................III
Dimensions ................................per LED strip 300 x 9 x 7 mm (L x B x H)

b) Wall plug transformer
Operating voltage ......................100 - 240 V AC, 50-60 Hz
Output ........................................12 V/DC, 1 A
Protection class .........................II

c) General
Total power consumption ...........approx. 8,1 W