Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 Fiche De Données

 Move the cursor to the gyro type selection

item and touch the RTN button to switch to

the data input mode. Select the gyro type

by scrolling the touch sensor.

 [GY]: When a Futaba GY gyro is used
 [NORM]: When other than Futaba GY gyro is

used

 Touch the RTN button to change the gyro

type and return to the cursor mode.

*When a Futaba GY gyro is used and [GY] type is selected, 

the sensitivity set value is directly read in both the AVCS 

and NORM modes.

 Move  the  cursor  to  the  operation  mode

selection  item  and  touch  the  RTN  button

to switch to the  data  input mode.  Select

the operation mode by scrolling the touch

sensor.

 [AVCS]: AVCS mode
 [NORM]: Normal mode
 Touch  the  RTN  button  to  change  the

operation mode and return  to the cursor

mode.

 

 Move the cursor to the rate item and touch

the RTN button to switch to the data input

mode.

 Adjust the sensitivity by scrolling the touch

sensor.

 Initial value: 80%
 Adjustment range: 0~100%

*When  the  RTN  button  is  touched  for  one  second,  the 

sensitivity is reset to the initial value.)

 Touch the RTN button to return to the cursor

mode.

 Move the cursor to the [--] item and touch

the  RTN  button  to  access  the  selection

screen. Select the control.

*For a description of the switch selection method, see the 

description at the back of this manual.

 Move the cursor to the rate item and touch

the RTN button to switch to the data input

mode.

 Adjust the trim rate by scrolling the touch

sensor.

 Initial value: 0%
 Adjustment range: -20~+20%

*When  the  RTN  button  is  touched  for  one  second,  the 

sensitivity is reset to the initial value.)

 Touch the RTN button to return to the cursor

mode.

Generally, gain is interlocked with condition

and changes a rate.

How  to  change  two  rates  in  the  same

condition here.

1.  Select  [GYRO]  at  the  Model  menu  and

access the setup screen shown below by

touching the RTN button.

2.  Move  the  cursor  to  the  [COND]  item

and touch the RTN button to access the

selection screen. Select the [SW]. Touch the

RTN button to return to the cursor mode.

3. # number shows the present switch state. In

the state of # 1 a cursor is moved to [--] and

RTN is pushed.

4. [SF] is chosen by [H/W SELECT] and then a

top is turned ON.

5. [TYPE GY] and [RATE] of a state of "#1=SF

top"are set up.

6. It is a setup of "#2". Move the cursor to the

[#1]  item  and  touch  the  RTN  button  to

access the selection screen. Select the [#2].

Touch the RTN button to return to the cursor

mode.

●

The number

of a SW state