Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 Fiche De Données

Codes de produits

1-F8075

<Before Use>

Rubber

grommet

Brass eyelet

Wood screw

Servo mount

2.3-2.6mm nut

washer

Rubber

grommet
Brass eyelet

Servo mount

2.3-2.6mm screw

(Helicopter)

(Airplane/Glider)

Servo lead wires

To prevent the servo lead cable from being

broken by vibration during flight, provide a

little slack in the cable and fasten it at suitable

points. Periodically check the cable during daily

maintenance.

Fasten about 5-10cm

from the servo outlet so

that the lead wire is neat.

Margin in the lead wire.

Mounting the power switch

When mounting a power switch to an airframe,

make a rectangular hole that is a little larger than

the total stroke of the switch so that you can turn

the switch ON/OFF without binding.

Avoid mounting the switch where it can be

covered by engine oil and dust. In general, it is

recommended to mount the power switch on the

side of the fuselage that is opposite the muffler.

Safety precautions when you install

receiver and servos

Warning

Connecting connectors

Be sure to insert the connector until it stops

at the deepest point.

How to protect the receiver from vibration and

water

Wrap the receiver with something soft such

as foam rubber to avoid vibration. If there is

a chance of getting wet, put the receiver in a

waterproof bag or balloon to avoid water.

Receiver's antenna

Never cut the receiver's antenna. Do not

bind the receiver's antenna with the cables

for servos.

Locate the receiver's antenna as far as

possible from metals or carbon fiber

components such as frames, cables, etc.

*Cutting or binding the receiver's antenna will reduce the ra-

dio reception sensitivity and range, and may cause a crash.

Servo throw

Adjust your system so that pushrods will not

bind or sag when operating the servos to the

full extent.

*If excessive force is continuously applied to a servo, the

servo could be damaged due to force on the gear train and/
or power consumption causing rapid battery drain.

Mounting servos

Use a vibration-proof rubber (such as rubber

grommet) under a servo when mounting the

servo on a servo mount. And be sure that the

servo cases do not touch directly to the metal

parts such as servo mount.

*If the servo case contacts the airframe directly, vibration

will travel to and possibly damage the servo.

Mounting the Servo