Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 Fiche De Données

Each transmitter has an individually assigned, unique ID code. In order to start operation, the receiver 

must be linked with the ID code of the transmitter with which it is being paired. Once the link is made, 

the ID code is stored in the receiver and no further linking is necessary unless the receiver is to be used 

with another transmitter. When you purchase additional R7008SB receivers, this procedure is necessary; 

otherwise the receiver will not work. 

1. Place the transmitter and the receiver close

to each other within half (0.5m) meter.

 
2. Turn on the transmitter. 
3. Select [SYSTEM] at the Linkage menu and 

access the setup screen shown below by 

touching the RTN button.

4. When you use two receivers on one model, 

you must change from [SINGLE] to [DUAL].

    *Only two receivers can be used. In 

"DUAL", two setting items come out. Input, 

respectively.

5. "F" will be chosen if it is used in France. others

"G" general.

6. When changing battery fail-safe voltage 

from the initial value 3.8V, voltage is 

changed here. 

* Only in FASSTest Mode.

7.[LINK] is chosen by scrolling and the RTN 

button is pushed. The transmitter will emit a 

chime as it starts the linking process.

8. When the transmitter starts to chime, power 

on the receiver. The receiver should link to 

the transmitter within about 1 second. 

9. If linking fails, an error message is displayed. 

Bring the transmitter closer to the receiver 

and repeat the procedure above from Step 2.

10. ACT will be chosen if telemetry is used. 

It is INH when not using it.

 

:You can do this through the LINKAGE Menu 

and scroll to System and press RTN.

ID  of  a  Primary

receiver displays.

In DUAL, a primary receiver 

is link previously. Next, a 

secondary receiver is link.

ID of a Secondary 

receiver displays.