Benq W1070 9H.J7L77.17E Manuel D’Utilisation

  29

  Using the projector

Adjusting the projected image

Adjusting the projection angle 

The projector is equipped with 1 quick-release adjuster foot and 1 
rear adjuster foot. These adjusters change the image height and 
projection angle. To adjust the projector:

1. Press the quick-release button and lift the front of the projector. 

Once the image is positioned where you want it, release the 
quick-release button to lock the foot in position.

2. Screw the rear adjuster foot to fine-tune the horizontal angle.
To retract the foot, hold up the projector while pressing the quick-release button, then slowly lower the 
projector. Screw the rear adjuster foot in a reverse direction.

Correcting picture distortion

Keystoning occurs when the projector is not perpendicular to the screen and is where the projected 
picture displays visible as a trapezoid shape like either of the following:

•  Two parallel sides (left and right, or top and bottom) but is noticeably wider on either side.
•  No parallel sides.
To correct the picture’s shape, you can perform the following steps.
1. Adjust the projection angle. Move the projector to be in front of the center of the screen with the 

center of the lens level with the screen.

2. If the picture is stilled distorted, or the projector is unable to be positioned as described above, you 

will need to manually correct the picture.

•  Using the remote control or projector

i. Press one of the Arrow/Keystone keys on the remote control or projector (Up  / , Down /

) to display the Keystone page.

ii. See step 

 below for further operation.

•  Using the OSD menu

i. Press MENU/EXIT and then press  /  until the Display menu is highlighted.

ii. Press  

to 

highlight 

Keystone and press MODE/ENTER. The keystone correction page 

displays.

iii. Press the key whose keystone icon is opposite to the shape of the projected picture. Continue 

pressing the same key or press the other keys until you are satisfied with the shape.

The values on the lower portion of the page change while pressing. When the values reach their 

maximum or minimum with repeated key presses, the picture’s shape will stop changing. You will 

not be able to change the picture further in that direction. 

2

1

 

/

.

 

/

.