Arnold Rak 5 m Heating Cable / HK-5,0-F Fiche De Données
Codes de produits
HK-5,0-F
Installationshinweis für Frostschutzkabel
mit Thermostat
mit Thermostat
R I C H T I G
Der Knopftemperaturregler befindet sich am Ende der
Heizleitung in der Endmuffe. Er muss mit der flachen
Seite am Rohr bzw. am zu überwachendem
Gegenstand an der kältesten Stelle angebracht
werden.
Heizleitung in der Endmuffe. Er muss mit der flachen
Seite am Rohr bzw. am zu überwachendem
Gegenstand an der kältesten Stelle angebracht
werden.
Bei anschließender Isolierung des Rohres genügt eine
einfache parallele Verlegung des Heizkabels.
Falls keine Isolierung verwendet wird, kann das Kabel
mit einem Abstand von 5 – 8 cm um das Rohr gewickelt
werden.
einfache parallele Verlegung des Heizkabels.
Falls keine Isolierung verwendet wird, kann das Kabel
mit einem Abstand von 5 – 8 cm um das Rohr gewickelt
werden.
F A L S C H
In diesem Beispiel überwacht der Knopftemperatur-
regler die Raumtemperatur und wird immer im Zustand
„AN“ gehalten.
regler die Raumtemperatur und wird immer im Zustand
„AN“ gehalten.
F A L S C H
In diesem Beispiel überwacht der Knopftemperatur-
regler die Raumtemperatur und wird immer im
Zustand „AN“ gehalten.
regler die Raumtemperatur und wird immer im
Zustand „AN“ gehalten.
Außerdem ist das Heizkabel viel zu eng gewickelt. Es
darf sich nicht berühren.
darf sich nicht berühren.
Fitting instruction for anti-freeze cable
with thermostat
with thermostat
C O R R E C T
The button temperature controller is at the end of the
heating line in the end sleeve. It must be attached with
the flat side at the pipe or at the coldest point at the
object to be monitored.
heating line in the end sleeve. It must be attached with
the flat side at the pipe or at the coldest point at the
object to be monitored.
The heating cable only needs to be laid parallel when
the pipe is then insulated. In the absence of insulation,
the cable can be wound around the pipe at a 5 – 8 cm
spacing.
the pipe is then insulated. In the absence of insulation,
the cable can be wound around the pipe at a 5 – 8 cm
spacing.
I N C O R R E C T
In this example the button temperature controller
monitors the ambient temperature and is always kept
"ON".
monitors the ambient temperature and is always kept
"ON".
I N C O R R E C T
In this example the button temperature controller
monitors the ambient temperature and is always kept
"ON".
monitors the ambient temperature and is always kept
"ON".
The heating cable has also been wound far too closely.
Contact is to be ruled out.
Contact is to be ruled out.
D
GB