Fujitsu fi-6110 PA03607-B061 Fiche De Données

Chapter 6 Daily Care

91

The inside of the scanner should be cleaned with a piece of 
cloth/Cleaning Paper moistened with Cleaner F1, or a sheet of 
Cleaning Wipe.
As the scanner continues to feed the documents, paper dust 
will accumulate inside the scanner and it may cause scanning 
errors.
As a guideline, clean the inside of the scanner every 1,000 
sheets scanned. Note that this guideline varies depending on 
the type of documents you scan. For instance, it may be 
necessary to clean more frequently when you scan 
documents on which the toner is not sufficiently fused.

Turn off the scanner and wait for at least 15 minutes.

For details, refer to 

Open the ADF.

For details, refer to 

.

Clean the following locations with a cloth/Cleaning Paper 
moistened with Cleaner F1, or a sheet of Cleaning Wipe.

z The glasses inside the ADF become very hot 

when the scanner is being used.
When cleaning the inside of the scanner, 
make sure to unplug the power cable and wait 
for at least 15 minutes before you start 
cleaning.

z When you perform cleaning, make sure that 

the inside is free of foreign matter, and be 
careful not to get your hand or the cloth 
caught on the pick spring (metal part) as a 
deformed pick spring (metal part) may cause 
injury.

z Do not use water or mild detergent to clean the inside of the 

scanner.

z It may take a long time to dry if an excessive amount of 

Cleaner F1 is used. Moisten the cloth with moderate 
quantity. Wipe off the cleaner completely to leave no 
residue on the cleaned parts.

Be careful not to have your fingers caught 
when the ADF closes.

Glass (×2)
*one on the opposite side

Pick Spring (metal part shown in gray)(×1)

Pick Roller (×1)

Ultrasonic Sensor (×2)
*one on the opposite side

Idler Roller (×4)

Feed Roller (×2)

Eject Roller (×2)

Pad Assy (×1)