Vermont Castings 1610 Fascicule

 

Installation Instructions

Contents:
1, Warming Shelf (#0210)  .......... 30002823, Defiant NC
or
1, Warming Shelf (#0200) ........... 30002477, Encore NC
2, Mittenracks ...................................................1601705
1, Bracket, Right .............................................30002479
1, Bracket, Left ...............................................30002478
1, Bracket, Dragon ...........................................1302220
2, Cap Screw 1/4-20 x 1/2” hex head ...............1201338
3, Cap Screw 1/4-20 x 5/8” hex head ...............1201372
3, Washers .......................................................1202473 
4, SS,Soc 1/4-20 x 7/16 ...................................1200422
1, 1/8” Allen Wrench
Tool Required:
7/16” open-end wrench
Warming Shelves add versatility to your stove; they 
keep foods warm at mealtime, and provide a convenient 
spot to store a kettle or pan when you top-load your 
stove. 
The Warming Shelf is designed to hold up to 30 
pounds. However, always place objects on a shelf 
carefully to avoid sudden impact. Containers left on the 
shelves or on the stove for long periods of time should 
have water in them to prevent damage from overheat-
ing. 
Take special care with stoves and shelves that are 
enamelled, to avoid chipping the finish.
Each Shelf includes a pair of nickel-plated mittenracks 
that are ideal for drying damp mittens, socks, dish tow-
els, etc. Do not leave combustible items unattended on 
the shelves or mittenracks for extended periods of time, 
however, as they may overheat. 

30002488  8/08  Rev. 6

KT186

Warming shelf

parts

2/22/01   djt

KT187

Fig. 2  Attach brackets to threaded holes in top plate.

KT186

Warming shelf

parts

2/22/01   djt

Front of 

Stove

Left Flat 

Bracket

Right Flat Bracket

Dragon Bracket

KT186

Mittenracks

Fig. 1  Warming shelf parts.

Warming 

Shelf

Levelling 

Set Screw

Levelling Set Screw

The Shelf installation is completed in three stages. At-
tach the two brackets loosely to the stove, leaving the 
screws loose enough to allow final adjustments. Then, 
position the shelf and adjust the brackets so the shelf 
fits correctly. Finally, tighten the screws.

1. Screw the levelling set screws into the bottom of the 

flat brackets as shown in Figure 1.

2. Screw the flat brackets to the stove. Pass a 1/4”-20 

x 1/2” hex-head cap screw up through each bracket 

and into the threaded hole in the stove’s top plate. 

(Fig. 2) Tighten the screws enough to secure the 

brackets, but keep them loose enough for the brack-

ets to move slightly. 

3. Attach the dragon bracket to the flat bracket at the 

front of the stove using a flat washer under the head 

of a 1/4”-20 x 5/8” screw. (Fig. 3) Tighten the screw 

only finger-tight.