Benq PB8250 Manuel D’Utilisation
Maintenance
38
Lamp Information
Use and Replacement of the Lamp
When the Lamp Indicator lights up red or a message appears suggesting it is time to replace
the lamp, please install a new lamp or consult your dealer. An old lamp may cause a mal-
function in the projector and in some instances the lamp may explode.
the lamp, please install a new lamp or consult your dealer. An old lamp may cause a mal-
function in the projector and in some instances the lamp may explode.
For more detailed information on the warning indicators, please refer to page
.
The Lamp indicator light and Temperature warning light will light up if the lamp becomes too
hot. Turn the power off, allow the projector to cool down before checking that the Air Filters
are not clogged (page
hot. Turn the power off, allow the projector to cool down before checking that the Air Filters
are not clogged (page
). If the Lamp or Temp indicator still lights up after turning the power
back on, please contact your dealer.
The following Lamp warning displays will remind you of the lamp condition.
Lamp Replacement
To reduce the risk of electrical shock, always turn the projector off and disconnect the power
cord before changing the lamp.
cord before changing the lamp.
To reduce the risk of severe burns, allow the projector to cool for at least 45 minutes before
replacing the lamp.
replacing the lamp.
To reduce the risk of injuries to fingers and damage to internal components, use caution when
removing lamp glass that has shattered into sharp pieces.
removing lamp glass that has shattered into sharp pieces.
Message
Status
The lamp has been in operation for 1980 hours. Install
a new lamp for optimal performance. If the projector is
normally run with Preset "Economic Mode" selected
(page
a new lamp for optimal performance. If the projector is
normally run with Preset "Economic Mode" selected
(page
), you may continue to operate the projector
until the 2980 hour lamp warning appears.
The lamp has been in operation for 2980 hours, the
power will shutdown in 20 hours time. A new lamp
should be fitted to avoid the inconvenience when the
projector runs out of lamp time.
power will shutdown in 20 hours time. A new lamp
should be fitted to avoid the inconvenience when the
projector runs out of lamp time.
The lamp has been in operation for over 3000 hours.
This message will flash in the center of the screen
together with the Lamp indicator lighting up red for 40
seconds. The projector will shutdown after 40 seconds.
The lamp MUST be replaced before the projector will
operate normally.
This message will flash in the center of the screen
together with the Lamp indicator lighting up red for 40
seconds. The projector will shutdown after 40 seconds.
The lamp MUST be replaced before the projector will
operate normally.