Furuno RC-1500-1T Manuel D’Utilisation
2-5
23. Press [Enter] to open the selection window.
Setup
9. Configuration
System Setup
01:53 97-08-04 (YY-MM-DD)
IOR
INMARSAT-C
DTE1
OFF
DTE1
IOR
INMARSAT-C
DTE1
OFF
DTE1
System Date & Time
Preferred NCS
MES Operation Mode
Active Port
Nav Port
Preferred NCS
MES Operation Mode
Active Port
Nav Port
Message Output Port
EGC Output Port
DTE1
DTE2
PC/DATA
AUTO
PC/DATA
AUTO
Figure 2-11 System setup menu, message output port
24. Select the DTE where you want to store receive messages.
DTE1:
All receive messages are routed to the main DTE
(connected to DTE1 on the communication unit)
regardless of sub address.
(connected to DTE1 on the communication unit)
regardless of sub address.
DTE2:
All receive messages are routed to the 2nd DTE
(connected to DTE2 on the communication unit)
regardless of sub address.
(connected to DTE2 on the communication unit)
regardless of sub address.
PC/DATA:
All receive messages are routed to the PC/DATA
(connected to PC/DATA on the communication unit)
regardless of sub address (not used).
(connected to PC/DATA on the communication unit)
regardless of sub address (not used).
AUTO:
Select to route messages with sub address 000 to
the main DTE, and messages with the sub address
of the 2nd DTE to the 2nd DTE. All other mes-
sages are routed to the main DTE.
the main DTE, and messages with the sub address
of the 2nd DTE to the 2nd DTE. All other mes-
sages are routed to the main DTE.
Note:
Do not select DTE2 or Auto when there is no DTE con-
nected to the DTE2 port; messages cannot be read from
the communications unit.
nected to the DTE2 port; messages cannot be read from
the communications unit.
25. Press [Enter] to close the selection window.
26. Press [
/
] to advance the cursor to the EGC Output Port line.
27. Press [Enter] to open the selection window.
Setup
9. Configuration
System Setup
01:53 97-08-04 (YY-MM-DD)
IOR
INMARSAT-C
OFF
DTE1
DTE1
IOR
INMARSAT-C
OFF
DTE1
DTE1
System Date & Time
Preferred NCS
MES Operation Mode
Nav Port
Active Port
Message Output Port
Preferred NCS
MES Operation Mode
Nav Port
Active Port
Message Output Port
EGC Output Port
DTE1
DTE1+DTE2
Figure 2-12 System setup menu, EGC output port
28. Select the DTE where you want to store receive EGC messages;
DTE1, DTE2 or PC/DATA.
29. Press [Enter] to close the selection window.