Eaton Electrical Wireless Office Headset SC200 Manuel D’Utilisation

Installation

3-10

IPN 997-00012-41D December 2006

Step 5 – Repeat for other battery cables (if required)

Repeat the above procedure to connect up to three battery strings to an APS6-
059 power system.

Step 6 – Remove knockout and fit cover

Remove the battery cable knockout(s) on the DC output cover.

Battery cable knockout.

Remove any sharp edges, in particular the remaining knock-out webs.

Fit the DC output cover.

Procedure complete

Installing the Battery Temperature Sensor (if batteries are fitted)

This section applies to APS3-059, APS3-061 and APS6-059 power systems only.

Each APS3-059, APS3-061 and APS6-059 power system is supplied with a battery
temperature sensor and standard 2 m (6.5 feet) long cable (factory-fitted to the sensor).

Longer cables are available from your local Powerware DC product representative or you
can make up your own. We strongly recommend limiting the maximum cable length of the
battery temperature sensor to 20 m (65 feet) because of noise considerations.

Connecting the Battery Temperature Sensor Cable

There are two screw-clamp terminal blocks at the rear of APS3-059, APS3-061 and APS6-059
power systems for terminating the battery temperature sensor cable, as shown below.

The two terminal blocks are labeled TEMP SENSOR (+) and TEMP SENSOR (-).