Yamaha Boat 60D Manuel D’Utilisation
Maintenance
48
5.
Check that the tilt rod and trim rods are
free of corrosion or other flaws.
free of corrosion or other flaws.
6.
Activate the tilt-down switch until the trim
rods have retracted completely into the
cylinders.
rods have retracted completely into the
cylinders.
7.
Activate the trim-up switch until the tilt
rod is fully extended. Unlock the tilt sup-
port lever.
rod is fully extended. Unlock the tilt sup-
port lever.
8.
Tilt the outboard motor down. Check
that the tilt rod and trim rods operate
smoothly.
that the tilt rod and trim rods operate
smoothly.
NOTE:
Consult your Yamaha dealer if any operation
is abnormal.
EMU29171
Checking propeller
WARNING
EWM00321
You could be seriously injured if the en-
gine accidentally starts when you are
near the propeller.
near the propeller.
●
Before inspecting, removing, or install-
ing the propeller, remove the spark
plug caps from the spark plugs. Also,
place the shift control in neutral, turn
the main switch to “
ing the propeller, remove the spark
plug caps from the spark plugs. Also,
place the shift control in neutral, turn
the main switch to “
” (off) and re-
move the key, and remove the lanyard
from the engine stop switch. Turn off
the battery cut-off switch if your boat
has one.
from the engine stop switch. Turn off
the battery cut-off switch if your boat
has one.
●
Do not use your hand to hold the pro-
peller when loosening or tightening the
propeller nut. Put a wood block be-
tween the anti-cavitation plate and the
propeller to prevent the propeller from
peller when loosening or tightening the
propeller nut. Put a wood block be-
tween the anti-cavitation plate and the
propeller to prevent the propeller from
turning.
Checkpoints
●
Check each of the propeller blades for
wear, erosion from cavitation or ventila-
wear, erosion from cavitation or ventila-
1. Tilt support lever
ZMU01896
ZMU01897