Bestop Washer/Dryer 39323 Manuel D’Utilisation

Adjust the height of the Adjustable Seat Legs to assure the seat back locks  securely into the Lock Down Brackets. If the Seat does not lock in place, it may tilt forward
unexpectedly which could result in serious injury to you and others.

Seat Back

Lock Down
Bracket

Tapping
Plate

Wheel Well

Lower the Seat onto the floor of the vehicle. Raise the Seat Back into the sitting
position. Locate the Lock Pin on the Seat Hinge

Orient the Left and Right Lock Down Brackets with the opening towards the top
and the rear of the vehicle. Place a Lock Down Bracket over the Lock Pin.  The
bracket should be at a 10 degree angle to the floor with the bottom of the bracket
tilted toward the rear (the bottom hole should be 3/4" rearward of the top hole).
Use the Lock Down Bracket as a template.  Mark the locations of the holes in the
bracket. Center punch the locations and drill a 21/64" hole at each mark.

While one person installs a Lock Down Bracket inside of the vehicle,  using two
M8-1.25 x 35mm Bolts a second person places a Tapping Plate and two M8-1.25
Hex Nuts over the holes from under the wheel well. Loosely tighten the bolts
using an adjustable wrench or 10mm wrench.

This procedure is repeated for the other side of the vehicle.

Adjust the seat height to make sure the seat locks into the Lock Down Brackets.

Tighten all eight (8) of the previously installed bolts and nuts with an adjustable
wrench or 10mm wrench.

Lock Down
Bracket

Adjust height to make sure
seat locks securely into Lock
Down Bracket

Lock Down
Bracket

Lock
Pin

3/4"
(bottom hole
rearward of top
hole)

Tapping Plate -
under wheel well

M8-1.25 x 35mm Bolt

M8-1.25 x 35mm
Bolts

Note: If replacing a factory seat, please remove all factory hardware and replace with Bestop hardware from the enclosed kit.

M8-1.25 Hex Nuts -
under wheel well