Whirlpool W10533016A Manuel D’Utilisation

3. Determine and mark centerline of the cutout space. The 

mounting can be installed on either the left side or right side 
of the cutout. Position mounting bracket against the wall in 
the cutout so that the V-notch of the bracket is 12

⁵³⁄₆₄" 

(32.6 cm) from centerline as shown.

4. Drill two 

¹⁄₈" (3 mm) holes that correspond to the bracket 

holes of the determined mounting method. See the following 
illustrations.

5. Using the Phillips screwdriver, mount anti-tip bracket to the 

wall or floor with the two #12 x 1

⁵⁄₈" screws provided.

6. Move range close enough to opening to allow for final gas 

and electrical connections. Remove shipping base, 
cardboard or hardboard from under range.

7. Move range into its final location, making sure rear leveling 

leg slides into anti-tip bracket.

8. Move range forward onto shipping base, cardboard or 

hardboard to continue installing the range using the following 
installation instructions.

A combination of pipe fittings must be used to connect the range 
to the existing gas line. Your connections may be different, 
according to the supply line type, size and location.

1. Apply pipe-joint compound made for use with LP gas to all 

pipe thread connections.

2. Using a pipe wrench to tighten, connect the gas supply to the 

range.

1. Apply pipe-joint compound made for use with LP gas to the 

smaller thread ends of the flexible connector adapters (see B 
and F in the following illustration).

2. Attach one adapter to the gas pressure regulator and the 

other adapter to the gas shutoff valve. Tighten both adapters.

⁵³⁄₆₄

Centerline

B

A

G

E

F

C

D

A

B