West Elm Gilding Window Track System Instructions De Montage
Proper fixing of brackets to the wall is essential for safety
The anchor plugs supplied are suitable for the use on walls of
concrete, prestressed hollow-core concrete slabs, natural stone
with dense structure wall, solid brick wall, sand-lime solid brick,
lightweight concrete, aircrete, solid gypsum wall, vertically
perforate brick, sand-lime perforated block, hollow block made
from lightweight concrete, slabs made of perforated bricks,
hollow concrete block etc.
concrete, prestressed hollow-core concrete slabs, natural stone
with dense structure wall, solid brick wall, sand-lime solid brick,
lightweight concrete, aircrete, solid gypsum wall, vertically
perforate brick, sand-lime perforated block, hollow block made
from lightweight concrete, slabs made of perforated bricks,
hollow concrete block etc.
Special anchors are required for gypsum plasterboard, gypsum
fiberboard, deep board panels. For any other types of installation
please consult a technician for proper guidance on the selection
of the anchor plug.
fiberboard, deep board panels. For any other types of installation
please consult a technician for proper guidance on the selection
of the anchor plug.
Use 6mm drill and drill a hole of at least 45mm(1.80in.)
Using a different size drill may result in improper anchor plug
fitting.
Using a different size drill may result in improper anchor plug
fitting.
Use only 4-5mm screws
Ensure screws are firmly fixed on to the brackets.
Drawing is not to scale
Safety
!
!
!
!
!
!
Extending the Track :
For connecting multiple tracks insert connector plate into
middle level of track leaving approx 1 3/8" sticking out. Tighten 2
set screws with allen key into track so connector does not move.
middle level of track leaving approx 1 3/8" sticking out. Tighten 2
set screws with allen key into track so connector does not move.
Slide 2nd track onto connector.
Installation of Track System-With Ceiling Bracket
*Mark desired distance between ceiling brackets on ceiling or
inside of window. Each track requires two brackets.
inside of window. Each track requires two brackets.
*Drill holes using 6mm drill and fix brackets as in illustration
above.
above.
Contents
Connectors
2 Wall Brackets
6 Screws & Wall Plug
End Caps
14 Gliders
Allen Key
12 Set Screw
2 Ceiling Brackets
2 Flat
Head Screws
Track
+ 1 extra screw, anchor plug, set screw & flat head screw
See installation of track system for further instructions
gliding track system
assembly instructions
Set Screw
Anchor Plug
Screw
Track Holder
* Remove one end cap by loosening set screw with allen key.
* Slide track holders in top level of track system.
Note: Include one track holder for each ceiling bracket.
* Slide gliders in bottom level.
* If extending track see extending track instructions.
* Attach end cap to track. Tighten with set screw.
* Place track holders up inside ceiling brackets and tighten
set screw in ceiling bracket using allen key.
Page 1/2