Whirlpool TGP302 Manuel D’Utilisation

Remove the burner cap from the burner base and clean 
according to “General Cleaning” section.

Clean the gas tube opening with a damp cloth.

Clean clogged burner ports with a straight pin as shown. Do 
not enlarge or distort the port. Do not use a wooden 
toothpick. If the burner needs to be adjusted, contact a 
trained repair specialist.

Replace the burner cap, making sure the alignment pins on 
the cap are properly aligned with the burner base.

Turn on the burner. If the burner does not light, check cap 
alignment. If the burner still does not light, do not service the 
sealed burner yourself. Contact a trained repair specialist.

Check burner flames occasionally for proper size 

and shape as shown below. A good flame is blue in color, not 
yellow. Keep this area free of soil and do not allow spills, food, 
cleaning agents or any other material to enter the burner ports.

Remove the surface burner grates.

Lift-up the cooktop. See the “Lift-up Cooktop” section.

Clean clogged burner ports with a straight pin as shown. Do 
not enlarge or distort the port. Do not use a wooden 
toothpick. If the burner needs to be adjusted, contact a 
trained repair specialist.

Close the cooktop.

Replace surface burner grates.

Turn on the burner. If the burner does not light, do not service 
the open burner yourself. Contact a trained repair specialist.

The lift-up cooktop provides easy access for cleaning beneath. 
Be careful not to drop the cooktop. Damage could occur to the 
finish and the cooktop frame. For more information, see the 
“General Cleaning” section.

Lift up the cooktop by both front corners until the supports 
lock into place.

Lift the cooktop from both sides while pressing the support 
rods back to unlock them.

Slowly lower the cooktop into place.