Whirlpool IGS365RS1 Manuel D’Utilisation

Storage Drawer

The storage drawer can be removed. Before removing, make sure
drawer is cool and empty.

To Remove:

1. Pull the storage drawer straight back past the drawer stop

notch and the end of the side rails.

2. Lift up the back of the drawer and pull the drawer out.

To Replace:

1. Lift up the back of the drawer and place it inside the range in

its fully forward position.

2. Lift up the front of the drawer to a level position.

3. Slowly push the drawer into the range until the drawer side

rails engage with the gap in the drawer glides.

4. Once the drawer is fully engaged on both sides, slide the

drawer back into the closed position.

NOTE: When removing and replacing the storage drawer, a
slight push may be needed to move the drawer stop notch
past the drawer glides.

TROUBLESHOOTING

Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.

Nothing will operate

■

Is the power supply cord unplugged?
Plug into a grounded 3 prong outlet.

■

Household fuse blown or circuit breaker tripped?
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.

Surface burners will not operate

■

Is this the first time the surface burners have been used?
Turn on any one of the surface burner knobs to release air
from the gas lines.

■

Is the control knob set correctly?
Push in knob before turning to a setting.

■

Are the burner ports clogged?
See “Sealed Surface Burners” section.

Surface burner flames are uneven, yellow and/or noisy

■

Are the burner ports clogged?
See “Sealed Surface Burners” section.

■

On models with caps, are the burner caps positioned
properly?
See “Sealed Surface Burners” section.

■

Is propane gas being used?
The appliance may have been converted improperly.
Contact a service technician or see “Assistance or Service”
section.

Surface burner makes popping noises

■

Is the burner wet?
Let it dry.

Excessive heat around cookware on cooktop

■

Is the cookware the proper size?
Use cookware about the same size as the surface cooking
area, element or surface burner. Cookware should not extend
more than ½" (1.3 cm) outside the cooking area.

Cooktop cooking results not what expected

■

Is the proper cookware being used?
See “Cookware” section.

■

Is the control knob set to the proper heat level?
See “Cooktop Controls” section.

■

Is the appliance level?
Level the appliance. See the Installation Instructions.

A. Drawer stop notch
B. End of side rail

A. Engage drawer glide