Whirlpool SF367LEMB0 Manuel D’Utilisation
6
COOKTOP USE
Cooktop Controls
Electric igniters automatically light the surface burners when
control knobs are turned to IGNITE.
control knobs are turned to IGNITE.
Before setting a control knob, place filled cookware on the grate.
Do not operate a burner using empty cookware or while the grate
is unoccupied.
Do not operate a burner using empty cookware or while the grate
is unoccupied.
To Set:
1.
Push in and turn knob counterclockwise to IGNITE.
All four surface burners will click. Only the burner with the
control knob turned to IGNITE will produce a flame.
control knob turned to IGNITE will produce a flame.
2.
Turn knob anywhere between HIGH and LOW. Use the
following chart as a guide when setting heat levels.
following chart as a guide when setting heat levels.
Power Burner
The left front burner is designed to give ultra-high power when it
is fully on. It can be used to rapidly bring liquid to a boil and to
cook large quantities of food.
is fully on. It can be used to rapidly bring liquid to a boil and to
cook large quantities of food.
Power Failure
In case of prolonged power failure, the surface burners can be lit
manually. Hold a lit match near a burner and turn knob
counterclockwise to IGNITE. After burner lights, turn knob to
setting.
manually. Hold a lit match near a burner and turn knob
counterclockwise to IGNITE. After burner lights, turn knob to
setting.
Surface Burners
IMPORTANT:
Do not obstruct the flow of combustion and
ventilation air around the burner grate edges.
Before cleaning, make sure all controls are off and the oven and
cooktop are cool. Do not use oven cleaners, bleach or rust
removers.
cooktop are cool. Do not use oven cleaners, bleach or rust
removers.
Burner cap:
Always keep the burner cap in place when using a
surface burner. A clean burner cap will help prevent poor ignition
and uneven flames. Always clean the burner cap after a spillover
and routinely remove and clean the caps according to the
“General Cleaning” section.
and uneven flames. Always clean the burner cap after a spillover
and routinely remove and clean the caps according to the
“General Cleaning” section.
Gas tube opening:
Gas must flow freely throughout the gas tube
opening for the burner to light properly. Keep this area free of soil
and do not allow spills, food, cleaning agents or any other
material to enter the gas tube opening. Protect it from spillovers
by always using a burner cap.
and do not allow spills, food, cleaning agents or any other
material to enter the gas tube opening. Protect it from spillovers
by always using a burner cap.
SETTING
RECOMMENDED USE
IGNITE
■
Light the burner.
HIGH
■
Start food cooking.
■
Bring liquid to a boil.
BETWEEN
HIGH and LOW
HIGH and LOW
■
Hold a rapid boil.
■
Quickly brown or sear food.
■
Fry or sauté foods.
■
Cook soups, sauces and gravies.
■
Stew or steam foods.
LOW
■
Keep food warm.
■
Melt chocolate or butter.
■
Simmer.
WARNING
Fire Hazard
Do not let the burner flame extend beyond the
edge of the pan.
edge of the pan.
Turn off all controls when not cooking.
Failure to follow these instructions can result in
death or fire.
death or fire.
REMEMBER: When range is in use or (on some
models) during the Self-Cleaning cycle, the entire
cooktop area may become hot.
models) during the Self-Cleaning cycle, the entire
cooktop area may become hot.
1. Burner Cap
2. Burner Base
3. Alignment Pins
4. Igniter
5. Gas Tube Opening
2. Burner Base
3. Alignment Pins
4. Igniter
5. Gas Tube Opening
1. 1-1
¹⁄₂ in. (25-38 mm)
2. Burner Ports
1
2
4
5
3
2
1