Whirlpool WGI925C0BS Manuel Du Propriétaire

1. Using two hands, grasp the door as shown in the following 

illustration. Locate the slots on each side of the oven cavity, 
and insert the oven door hinges into the slots.

2. Open the oven door.

You should hear a “click” as the door is set into place.

3. Lower the oven door to the fully open position.

4. Move the oven door hinge locks back to the locked position. 

Check that the door is free to open and close. If it is not, 
repeat the previous steps.

■

Has a household fuse blown, or has a circuit breaker 
tripped?
Replace the fuse or reset the circuit breaker. If the problem 
continues, call an electrician.

■

Is the cooktop control set correctly?
Touch the display area on the control panel to select a 
cooking surface before selecting a function.

■

On ceramic glass models, is the oven control lockout set?
See “Control Lockout” section.

■

Has the cooktop turned off by itself?
The Power key was unintentionally touched. Press POWER 
again. Reset the cooktop.

■

Is the cookware the proper size?
Use cookware about the same size as the surface cooking 
area, element or surface burner. Cookware should not extend 
more than ½" (1.3 cm) outside the cooking area.

■

Does the Hot Surface indicator light stay on after control 
knob(s) have been turned off?
See “Cooktop Controls” section.

■

Is the proper cookware being used?
See “Cookware” section.

■

Is the cooktop control set to the proper heat level?
See “Cooktop Controls” section.

■

Is the range level?
Level the range. See the Installation Instructions.

■

Is the electronic oven control set correctly?
See “Electronic Oven Controls” section.

■

Has a delay start been set?
See “Timed/Delay Cooking” section.

■

On some models, is the oven control lockout set?
See “Control Lockout” section.

■

On some models, is the Sabbath Mode set?
See the “Sabbath Mode” section.

■

Does the oven temperature calibration need adjustment?
See “Oven Temperature Control” section.

■

Do the oven indicator lights flash?
See the “Display” and/or the “Oven Lights” section. If the 
indicator light(s) keeps flashing, call for service. See 
“Assistance or Service” section.

■

Have the tones been deactivated?
See “Tones” in the “Settings” section.

■

Is the oven display showing “12:00”?
There has been a power failure. Clear the display. See 
“Display” section. On some models, reset the clock, if 
needed. See the “Clock” section.

■

Is the oven display showing a letter followed by a 
number?
Press any CANCEL to clear the display. See “Display” in the 
“Electronic Oven Controls” section. If it reappears, call for 
service. See “Assistance or Service” section.