Whirlpool 1200 Guide De Montage

8. Connect the green (or yellow/green) ground wire to the 

green/yellow ground wire (H) in the terminal box using UL 
listed wire connectors.

9. Reinstall the in-line blower terminal box cover and screw.

10. Reinstall the front cover of the in-line blower housing and 

secure it with 10 mounting screws.

1. With the range hood mounted (see the range hood installation 

instructions), locate the wiring cable connector inside the 
range hood.

2. Connect the 6-wire connector assembly supplied with the 

in-line blower motor system to the mating cable connector 
from the range hood. 

3. Locate the terminal box inside the range hood and install a 

¹⁄₂" (1.3 cm) UL listed or CSA approved strain relief (see the 
range hood installation instructions). 

4. Run the wire ends from the 6-wire connector assembly 

through the 

¹⁄₂" (1.3 cm) strain relief, leaving enough wire 

length to make the wiring connections. Tighten the strain 
relief screws.

5. Connect the wires from the 6-wire connector assembly to the 

wires from the wiring conduit inside the range hood terminal 
box. 

6. Connect the same color wires to each other (black to black, 

white to white, etc.) using UL listed wire connectors.

NOTE: Connect the green (or green/yellow) ground wire from 
the wiring conduit to the green (or bare) ground wire from the 
home power supply using UL listed wire connectors (see the 
“Make Electrical Power Supply Connections to Range Hood” 
section in the range hood installation instructions).

7. Connect the home power supply wiring to the range hood 

following the instructions that are supplied with the range 
hood.  

8. Reinstall the range hood terminal box cover.

9. Reconnect power.  

¹⁄₂

A

B

C

D

E

F

G

H

I