Henny Penny Heated Merchandisers HMR-103 Manuel D’Utilisation
Model HMR-103,104,105,106,107
NEMA NUMBERS:
Model 208/240-1 ph
208-3 ph
240-3 ph
107
14-50P
L21-30P Hardwire
106
14-50P
L21-30P Hardwire
105
14-50P
L21-30P Hardwire
104
L14-30P
L21-20P Hardwire
103
L14-30P
L21-20P Hardwire
2-3. ELECTRICAL
CONNECTION
The heated merchandiser is available from the factory, wired for
120/208-240 volts, single or three phase, (includes neutral), 220-240
volts, or 380-415 volts. Refer to the table at left, and bottom, for proper
power connection.
120/208-240 volts, single or three phase, (includes neutral), 220-240
volts, or 380-415 volts. Refer to the table at left, and bottom, for proper
power connection.
This unit must be adequately and safely grounded. Refer to
local electrical codes for correct grounding procedures. If
heated merchandiser is not adequately grounded, electrical
shock could result.
heated merchandiser is not adequately grounded, electrical
shock could result.
(FOR EQUIPMENT WITH CE MARK ONLY!)
To prevent electric shock hazard this appliance must be
To prevent electric shock hazard this appliance must be
bonded to other appliances or touchable metal surfaces in
close proximity to this appliance with an equipotential
bonding conductor. This appliance is equipped with an
equipotential lug for this purpose. The equipotential lug is
marked with the following symbol
close proximity to this appliance with an equipotential
bonding conductor. This appliance is equipped with an
equipotential lug for this purpose. The equipotential lug is
marked with the following symbol
A separate disconnect switch with proper capacity fuses or breakers
must be installed at a convenient location between the unit and the
power source.
must be installed at a convenient location between the unit and the
power source.
International units are not supplied with cord and plug, and
must be provided upon installation. If two CE units are
placed side-by-side, a grounding wire needs to be placed
between the equipotential bonding lugs, located under the
cutting board brackets, of both units.
must be provided upon installation. If two CE units are
placed side-by-side, a grounding wire needs to be placed
between the equipotential bonding lugs, located under the
cutting board brackets, of both units.
2-2
1004