Blaupunkt DAKOTA RCR 127 Manuel D’Utilisation
20
3
TS/FM
Selector key to access the memory
banks I, II and T.
To switch over:
Press TS/FM as many times as re-
quired.
Selector key to access the memory
banks I, II and T.
To switch over:
Press TS/FM as many times as re-
quired.
Travelstore
To store and recall the five most pow-
erful stations with Travelstore.
To store: Press button for approxi-
mately 1 sec. until you hear a beep
and “T-STORE” appears in the display.
To recall: Select the memory bank “T”
and press the corresponding preset
button (1-5) briefly.
To store and recall the five most pow-
erful stations with Travelstore.
To store: Press button for approxi-
mately 1 sec. until you hear a beep
and “T-STORE” appears in the display.
To recall: Select the memory bank “T”
and press the corresponding preset
button (1-5) briefly.
4
Cassette ejection
Press .
Press .
5
Cassette loading slot
Insert the tape with side A or 1 facing
up, the open side showing to the right.
Insert the tape with side A or 1 facing
up, the open side showing to the right.
Switching on with the ignition being
switched off:
To keep on operating the set when the
ignition is switched off (KeyCard is in-
serted), proceed as follows:
Turn the knob to switch the unit off,
wait for about 2 seconds and turn it on
again.
To avoid that the battery goes flat, the
system will be turned off automatically
after one hour of playback.
switched off:
To keep on operating the set when the
ignition is switched off (KeyCard is in-
serted), proceed as follows:
Turn the knob to switch the unit off,
wait for about 2 seconds and turn it on
again.
To avoid that the battery goes flat, the
system will be turned off automatically
after one hour of playback.
2
SCA / SRC
SCA – Preset Scan
Press SCA/SRC for about 1 second -
The stations stored on the preset but-
tons will be scanned.
The indicators for the waveband, mem-
ory bank and preset button will flash in
the display.
SCA – Preset Scan
Press SCA/SRC for about 1 second -
The stations stored on the preset but-
tons will be scanned.
The indicators for the waveband, mem-
ory bank and preset button will flash in
the display.
To stop Preset Scan:
Press SCA/SRC again for about 1 sec-
ond.
Press SCA/SRC again for about 1 sec-
ond.
SRC (Source)
Press SRC/SRC briefly –
You can switch between radio and
cassette mode, if a cassette is insert-
ed.
Press SRC/SRC briefly –
You can switch between radio and
cassette mode, if a cassette is insert-
ed.
Quick reference
1
On
Off
Volume
When switching the set on with the
knob, the KeyCard has to be inserted.
The unit will play with the pre-
adjusted volume.
When switching the set on with the
knob, the KeyCard has to be inserted.
The unit will play with the pre-
adjusted volume.
Switching on/off with the KeyCard:
The set has to be turned on with the
knob.
The set has to be turned on with the
knob.
Notice:
Read the information in chapter “Key-
Card theft protection system”.
Read the information in chapter “Key-
Card theft protection system”.
Switching on/off via the ignition:
When connected correspondingly, the
set can also be turned on and off with
the vehicle ignition.
After the ignition has been switched
off, a double beep tone will remind you
that you should remove the KeyCard
before leaving your vehicle.
When connected correspondingly, the
set can also be turned on and off with
the vehicle ignition.
After the ignition has been switched
off, a double beep tone will remind you
that you should remove the KeyCard
before leaving your vehicle.
Dakota RCR127 gb®
02.05.2002, 10:26 Uhr
20