Bunn BT-10 (Thermal Carafe) Manuel Du Propriétaire
5
GENERAL INFORMATION
NOTE - THE BREWER IS NOT READY TO PLUG IN
(See Page 6)
Improper installation will result in permanent damage and void the
limited warranty. Read and follow the instructions on the next page.
• This brewer is designed to remain plugged in at all times
limited warranty. Read and follow the instructions on the next page.
• This brewer is designed to remain plugged in at all times
(except during initial installation or when cleaning).
• A vacation switch is provided on the lower left side to completely shut
off all electrical components when your plans take you away from home
for three or more days. Safety features, designed into the BUNN® coffee
brewer, make the daily use of this switch unnecessary.
for three or more days. Safety features, designed into the BUNN® coffee
brewer, make the daily use of this switch unnecessary.
• If the brewer has been shut off or unplugged, fill the tank with water
and allow the water in the tank to heat to the proper temperature before
using (about fifteen minutes or until the heating sound stops).
using (about fifteen minutes or until the heating sound stops).
• Your BUNN
®
coffee brewer has a specially designed tank to keep the
water at the proper temperature. This constant supply of hot water
assures correctly brewed coffee in less than three minutes.
assures correctly brewed coffee in less than three minutes.
•
The brewed coffee flows into a non-heated thermal carafe
server. The stainless steel construction will hold coffee at
serving temperature for 2 hours minimum.
server. The stainless steel construction will hold coffee at
serving temperature for 2 hours minimum.
• The carafe lid reduces coffee evaporation and temperature loss.
• While coffee is being brewed, the newest water in the tank is heated to
• While coffee is being brewed, the newest water in the tank is heated to
the proper temperature and held until needed.
• When the brewer is not in operation, the flip lid should be closed. If the
lid is left open, water could drip from the sprayhead when cold water
is poured into the top of the brewer.
is poured into the top of the brewer.
• Use CAUTION when dispensing hot water from the brewer. The water
is approximately 50°F hotter than that available from your hot water
faucet and is always available for other uses.
faucet and is always available for other uses.
• The brewer is equipped with a 120 volt, 3-prong, grounded cord set. The
plug is provided with a round grounding pin. This is a safety feature and
allows the plug to fit into a properly grounded outlet. If the plug does
not fit into the outlet, contact an electrician to update your outlet. Do
not attempt to bypass the safety aspect of this plug.
allows the plug to fit into a properly grounded outlet. If the plug does
not fit into the outlet, contact an electrician to update your outlet. Do
not attempt to bypass the safety aspect of this plug.
• The sprayhead may periodically become loose. Using extreme caution
since it may be hot, retighten the sprayhead with your finger tips.
NOTE- A severe burn may result if the sprayhead becomes
loose and falls off while brewing.