Bunn Coffee Grinder G9T HD Manuel Du Propriétaire

Page 3

 Introduction ---------------------------------------------------- 3

 

User Notices --------------------------------------------------- 3

 

Electrical Requirements -------------------------------------- 4

 

CE Requirements ---------------------------------------------- 4

 

Initial Set Up --------------------------------------------------- 4

Operating Controls -------------------------------------------- 4

 Cleaning -------------------------------------------------------- 5

 

Preventive Maintenance -------------------------------------- 5

 

Coffee Grinding ------------------------------------------------ 6

 Adjustments --------------------------------------------------- 6

This equipment will store up-to nine pounds of whole bean coffee and grind it to a preset grind and amount into an 

awaiting funnel and filter from most commercial drip coffee brewers. The equipment is only for indoor use on a sturdy 

counter or shelf. Adequate space must be available above the grinder to raise the lid when adding beans. Use only with 

whole bean coffee.

The grind is preset at the factory to drip specifications as set forth by the United States Department of Commerce and 

adopted by the Coffee Brewing Center of the Pan American Coffee Bureau. Adjustments may be made to alter both the 

amount and grind from the factory setting.

Carefully read and follow all notices on the grinder and in this manual.  They were written for your protection.  

All notices on the grinder are to be kept in good condition.  Replace any unreadable or damaged labels.

KEEP FINGERS AND

FOREIGN OBJECTS

OUT OF HOPPER

OR CHUTE OPENING.

PERSONAL INJURY

HAZARD.

20545-0000D  01/04  © 1990  Bunn-O-Matic Corporation 

READ THE ENTIRE OPERATING MANUAL 

INCLUDING THE LIMIT OF WARRANTY AND 

LIABILITY BEFORE BUYING OR USING THIS PRODUCT 

An extension cord, when used, must be shorter 

than 20 feet if 16-gage 3-conductor wire, or 

shorter than 10 feet if 18-gage 3-conductor wire. 

FAILURE TO COMPLY RISKS EQUIPMENT 

DAMAGE, FIRE, OR SHOCK HAZARD 

Use only on a properly protected circuit 
capable of the rated load. 
Electrically ground the chassis. 
Follow national/local electrical codes. 
Do not use near combustibles. 

10171 040612

#05876.0000

#20545.0000

#37881.0000

00824.0002