Benq Projector W6500 Manuel D’Utilisation

  21

  Using the projector

Eng
lish

Selecting an input source

The projector can be connected to multiple equipment at the same time. 
When the projector is first turned on, it will attempt to reconnect with the 
input source which was in use when the projector was last shut down.

To select the video source:
•  Using the remote control or projector

Press one of the Source keys on the remote control, or press SOURCE on 
the projector repeatedly until your desired signal is selected.

•  Using the OSD menu

1. Press MENU and then press  /  until the System Setup menu is 

highlighted.

2. Press  

to 

highlight 

Input Source and press ENTER. The source 

selection bar displays.

3. Press  /  repeatedly until your desired signal is selected and press 

ENTER.
Once detected, the selected source information will display on the 
screen for seconds. If there are multiple pieces of equipment 
connected to the projector, you can go back to the source selection bar 
again to search for other signals.

•  If you want the projector to automatically search for the signals, select 

On in the System Setup > Auto Source Search menu.

•  If you want to use the PIP function, see 

 for details.

Fine-tuning the image size and clarity

NOTE: When 
automatically 
searching for a 
valid input 
source, the 
projector cycles 
through the 
available signals 
following the 
sequence from 
top to bottom as 
the source 
selection bar 
shows.

1. Adjust the projected picture to the size that 

you need using the zoom ring.

2. Sharpen the picture by rotating the focus 

ring.