Benq Projector W1200 Manuel D’Utilisation
Operation
22
Operation
Starting up the projector
1.
Plug the power cord into the projector and into a
power outlet. Turn on the power outlet switch
(where fitted). Check that the POWER indicator
light on the projector lights red after power has
been applied.
power outlet. Turn on the power outlet switch
(where fitted). Check that the POWER indicator
light on the projector lights red after power has
been applied.
•
Please use the original accessories (e.g. power
cable) only with the device to avoid possible
dangers such as electric shock and fire.
cable) only with the device to avoid possible
dangers such as electric shock and fire.
•
If Direct power on function is activated in the SYSTEM SETUP > Operation Settings menu,
the projector will turn on automatically after the power cord has been connected and
power has been applied.
the projector will turn on automatically after the power cord has been connected and
power has been applied.
2.
Remove the lens cap. If it is closed, it could
become deformed due to the heat produced by
the projection lamp.
become deformed due to the heat produced by
the projection lamp.
3.
Press
Power on the projector or remote
control to start the projector. The POWER
indicator light flashes and stays green when the
projector is on.
The start up procedure takes about 30 seconds.
In the later stage of start up, a startup logo is
projected.
(If necessary) Rotate the focus ring to adjust
the image clearness.
indicator light flashes and stays green when the
projector is on.
The start up procedure takes about 30 seconds.
In the later stage of start up, a startup logo is
projected.
(If necessary) Rotate the focus ring to adjust
the image clearness.
If the projector is still hot from previous activity, it will run the cooling fan for approximately 90
seconds before energizing the lamp.
seconds before energizing the lamp.
4.
If the projector is activated for the first time,
select your OSD language following the on-
screen instructions.
select your OSD language following the on-
screen instructions.
5.
If you are prompted for a password, press the
arrow keys to enter a six digit password. See
arrow keys to enter a six digit password. See
for details.
6.
Switch all of the connected equipment on.
7.
The projector will start to search for input
signals. The current input signal being scanned
displays in the screen. If the projector doesn't
detect a valid signal, the message 'No Signal'
will continue displaying until an input signal is
found.
signals. The current input signal being scanned
displays in the screen. If the projector doesn't
detect a valid signal, the message 'No Signal'
will continue displaying until an input signal is
found.
I
I