Benq Projector MX511 Manuel D’Utilisation

Page de 70
Introduction
13
Infra-Red (IR) remote control sensor is located on the front of the projector. The remote 
control must be held at an angle within 30 degrees perpendicular to the projector's IR 
remote control sensor to function correctly. The distance between the remote control and 
the sensor should not exceed
 
8 meters (~ 26 feet).
Make sure that there are no obstacles between the remote control and the IR sensor on the 
projector that might obstruct the infra-red beam.
Replacing the remote control battery
1.
Pull out the battery holder.
Please follow the illustrated instructions. Push and hold 
the locking arm while pulling out the battery holder.
2.
Insert the new battery in the holder. Note the 
positive polarity should face outward.
3.
Push the holder into the remote control.
Avoid excessive heat and humidity. 
There may be battery damage if the battery is 
incorrectly replaced. 
Replace only with the same or equivalent type recommended by the battery manufacturer.
Dispose of the used battery according to the battery manufacturer’s instructions.
Never throw a battery into a fire. There may be danger of an explosion. 
If the battery is dead or if you will not be using the remote control for a long time, remove 
the battery to prevent damage to the remote control from possible battery leakage.
15.
Timer On
Activates or displays an on-screen timer 
based on your own timer setting. See 
 for details.
16.
Timer Setup
Enters presentation timer setting directly. 
See 
 for details.
Operating the projector from the front
Operating the projector from the rear
Approx. 1
Approx. 1