Benq Projector MX511 Manuel D’Utilisation
Operation
42
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences. The
following settings do not affect the projection settings, operation, or performance.
following settings do not affect the projection settings, operation, or performance.
•
Menu display time in the SYSTEM SETUP: Basic > Menu Settings menu sets the length
of time the OSD will remain active after your last key press. The time length ranges from
5 to 30 seconds in 5-second increments. Use
of time the OSD will remain active after your last key press. The time length ranges from
5 to 30 seconds in 5-second increments. Use
/
to select a suitable time frame.
•
Menu position in the SYSTEM SETUP: Basic > Menu Settings menu sets the OSD
position in five locations. Use
position in five locations. Use
/
to select a preferred position.
•
Language in the SYSTEM SETUP: Basic menu sets your familiar language for the OSD
menus. Use
menus. Use
/
to select your language.
•
Reminder Message in the SYSTEM SETUP: Basic > Menu Settings menu sets whether to
display reminder messages on screen. Use
display reminder messages on screen. Use
/
to select your desired setting.
•
Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo screen to be
displayed during projector start-up. Use
displayed during projector start-up. Use
/
to select a screen.
Shutting down the projector
1.
Press
Power and a confirmation message
displays prompting you.
If you don't respond in a few seconds, the
message will disappear.
If you don't respond in a few seconds, the
message will disappear.
2.
Press
Power a second time. The POWER
indicator light flashes orange, the projection
lamp shuts down, and the fans will continue to
run for approximately 90 seconds to cool down
the projector.
lamp shuts down, and the fans will continue to
run for approximately 90 seconds to cool down
the projector.
•
To protect the lamp, the projector will not respond
to any commands during the cooling process.
to any commands during the cooling process.
•
To shorten the cooling time, you can also activate
the Quick Cooling function. See
the Quick Cooling function. See
for details.
3.
Once the cooling process finishes, the POWER
indicator light is a steady orange and fans stop.
indicator light is a steady orange and fans stop.
4.
Disconnect the power cord from the power putlet if the projector will not be used in
an extended period of time.
an extended period of time.
•
If the projector is not properly shut down, to protect the lamp, when you attempt to re-start
the projector, the fans will run for a few minutes to cool down. Press Power again to start
the projector after the fans stop and the POWER indicator light turns orange.
the projector, the fans will run for a few minutes to cool down. Press Power again to start
the projector after the fans stop and the POWER indicator light turns orange.
•
Actual lamp life may vary due to different environmental conditions and usage.
I
I
I
I