Benq Professional VP150X Manuel D’Utilisation
8
English
OPERATION
Turn On/Off Procedure
A
Power on
Press the Standby/On key to turn on the lamp. The LED will blink green during warm up and then light solid green.
z
“INPUT SIGNAL DETECTED, ACTIVATING AUTO IMAGE” will be displayed on the screen after the
projector identifies the input signal.
projector identifies the input signal.
z
“SEARCHING” message will be displayed on the screen if there is no signal input.
z
“SYNC IS OUT OF RANGE” message will be displayed on the screen if the horizontal frequency of the input
signal exceeds the range of the projector.
signal exceeds the range of the projector.
B
Standby
Press the Standby/On key for more than one second to turn off the lamp. The LED will then blink orange and the lamp
will shut down, but the fans will continue to run for about 1 minutes to cool the lamp. After the fans stop, the LED will
turn to a solid orange light.
will shut down, but the fans will continue to run for about 1 minutes to cool the lamp. After the fans stop, the LED will
turn to a solid orange light.
*Lamp Protection Procedure: If you try to turn on the lamp again while the LED is blinking, the projector will ignore the command
until it is cooled down for one minute.
until it is cooled down for one minute.
External Control
A Control
Pad
Figure 13. External control pad
STANDBY/ON
Lampr status indicator
SOURCE
EXIT
Standby/On indicator
Menu
3