BENDIX SD-03-10433 Fascicule
1
Bendix
®
FCS-9700
™
Fan Clutch Solenoid
SD-03-10433
DESCRIPTION
The Bendix
®
FCS-9700
™
fan clutch solenoid, shown in
Figure 1, is a low air fl ow solenoid used to control the fan
clutch. A thermostat controls the solenoid operation.
clutch. A thermostat controls the solenoid operation.
The fan clutch solenoid is always mounted as a stand
alone solenoid. Depending on the application, it can be a
normally closed (NC) or normally open solenoid (NO). The
integral mounting bracket comes in a right or left position
and is not removable.
alone solenoid. Depending on the application, it can be a
normally closed (NC) or normally open solenoid (NO). The
integral mounting bracket comes in a right or left position
and is not removable.
OPERATION
Because this solenoid valve is used for an auxiliary air
function, a pressure protection valve, such as a Bendix
function, a pressure protection valve, such as a Bendix
®
PR-3
™
valve, must be installed to protect the air brake
system. Based on the application, the solenoid will
deliver or exhaust air. See Figure 2 for a typical system
confi guration.
deliver or exhaust air. See Figure 2 for a typical system
confi guration.
PREVENTIVE MAINTENANCE
Important: Review the Bendix Warranty Policy before
performing any intrusive maintenance procedures. The
warranty may be voided if intrusive maintenance is
performed during the warranty period.
performing any intrusive maintenance procedures. The
warranty may be voided if intrusive maintenance is
performed during the warranty period.
DELIVERY
PORT
SUPPLY PORT
FIGURE 1 - BENDIX
®
FCS-9700
™
FAN CLUTCH SOLENOID VALVES
EXHAUST
PORT
MOUNTING
BRACKET
(LEFT HAND)
ELECTRICAL
CONNECTOR
No two vehicles operate under identical conditions; as
a result, maintenance intervals may vary. Experience is
a valuable guide in determining the best maintenance
interval for air brake system components. At a minimum,
the solenoid should be inspected every 6 months or
1500 operating hours, whichever comes fi rst, for proper
operation. Should the solenoid not meet the elements
of the operational tests noted in this document, further
investigation and service of the valve may be required.
a result, maintenance intervals may vary. Experience is
a valuable guide in determining the best maintenance
interval for air brake system components. At a minimum,
the solenoid should be inspected every 6 months or
1500 operating hours, whichever comes fi rst, for proper
operation. Should the solenoid not meet the elements
of the operational tests noted in this document, further
investigation and service of the valve may be required.
SERVICE CHECKS
When the in-cab switch is pressed to activate or deactivate
the fan clutch, the Bendix FCS-9700
the fan clutch, the Bendix FCS-9700
solenoid will promptly
exhaust (NO) or apply (NC). Note that the solenoid part
number label is marked with an NO or NC for identifi cation.
Continuous exhausting of air pressure should not occur.
number label is marked with an NO or NC for identifi cation.
Continuous exhausting of air pressure should not occur.
LEAKAGE CHECKS
With the air system fully charged, coat the exhaust ports
of the solenoid with a soap solution. A 1-inch bubble in
three (3) seconds is permitted (175 SCCM).
of the solenoid with a soap solution. A 1-inch bubble in
three (3) seconds is permitted (175 SCCM).
EXHAUST
PORT
SUPPLY PORT
DELIVERY
PORT
ELECTRICAL
CONNECTOR
NORMALLY OPEN (NO)
SOLENOID
NORMALLY CLOSED
(NC) SOLENOID
MOUNTING
BRACKET
(LEFT HAND)