BENDIX TCH-013-014 Fiche De Données

©2006 Bendix Commercial Vehicle Systems LLC   10/06.   All Rights Reserved.   Printed in U.S.A.

Figure 1 - Installing the Bendix

®

  TABS-6 ABS Controller Cover

The Bendix

®

 TABS-6 ABS Module uses a locked cover, 

similar to some other Bendix ABS units, to protect the 
wheel speed sensor and ECU connections from damage, 
road spray, grime, etc.  

Incorrect installation can lead to the cover being broken or 
lost.  Please follow the procedure outlined below.

To install the cover, check to confi rm that all the connectors 
are fully installed into position at the top of the housing.  
Reinsert the bottom edge of the cover into the hinges and 
lean the cover forward into position.  Slide the locking tab 
to the right to lock it.  As an option, a tie-wrap may be used 
through the lugs provided.

Note:  The cover has internal channels that will prevent 
the cover from closing freely if the wheel speed harness 
connectors are not fully in position - if resistance is 
experienced, check these connections.  

Bendix service replacement cover p/n is 802028.

See the Service Data sheet for more information.

Figure 2 - Locking the Bendix

®

  TABS-6 ABS Controller

Lugs for Optional 

Tie-Wrap Installation

Hinge Point (2)

Bendix

®

 TABS-6 Trailer ABS Module  . . . . . .  SD-13-4767 (BW2469)

ABS Repair and Diagnostics DVD . . . . . . . . . . . . . . . . . . . .BW2538

Visit the Literature Center on www.bendix.com for free downloads of 
Service Data sheets or to order copies.

Figure 3 - Harness Connector Position

Shows 

Connector Not 

Fully Seated

Shows Connector Fully 

Seated in Correct Position.

Note: Tab Installs in Slot