GE General Electric Plumbing Product GNUL30B Manuel D’Utilisation

11

The bracket can be used as a template for marking the location of the mounting screws. When determining

the location of the bracket make sure you leave 1-1⁄2

″ 

to 2

″ 

of free area under the sumps to allow for sump

removal and enough space on either side to make the tubing connections.

Run the length of 3⁄8

″

tubing, connected to the bottom of faucet, to the filter system outlet, Fig.1 in the

Installation Overview 

section. Allow enough slack in the tubing to be able to place the system on the floor

in front of the sink. Measure and cut the end of the tubing square.

Slide a compression nut onto the end of the tubing and push a tubing insert into the tubing.

Connect the tubing and tighten the compression nuts securely.

Repeat the preceding steps to connect a length of tubing between the filter system inlet and the water

supply/saddle valve, Fig. 1 in the Installation Overview section.

In a dry location, within reach of the electronic base 3

′ 

leadwire, select a place for the battery pack (see

Fig. 1 on page 8). The battery pack attaches to most surfaces, using the included “sticky-back” Velcro™

strip.
The battery pack uses two size “AA” batteries. Check to be sure they are installed correctly. Then,

remove the paper backing on the Velcro™ strip and secure the pack in place.
Fasten electronic base leadwire and battery pack connector together.

Fig. 4

Filter

Ι

Filter

ΙΙ

Sump

Mounting
screws

Tubing
connector

Tubing
connector

Mounting
bracket

Sump

7-9⁄16

″

1-1⁄2

″

to 2

″