Behringer behringer eg2180 Manuel D’Utilisation

EUROGRAND EG2180

Headphone Hanger Assembly

Technical specifications and appearance are subject to change without notice. The information contained herein is correct at the time of printing. All trademarks (except BEHRINGER,

the BEHRINGER logo, JUST LISTEN and EUROGRAND) mentioned belong to their respective owners and are not affiliated with BEHRINGER. BEHRINGER accepts no liability

for any loss which may be suffered by any person who relies either wholly or in part upon any description, photograph or statement contained herein. Colors and specifications

may vary slightly from product. Products are sold through our authorized dealers only. Distributors and dealers are not agents of BEHRINGER and have absolutely no authority to

bind BEHRINGER by any express or implied undertaking or representation. No part of this manual may be reproduced or transmitted in any form or by any means, electronic or

mechanical, including photocopying and recording of any kind, for any purpose, without the express written permission of BEHRINGER International GmbH.

Hanns-Martin-Schleyer-Str. 36-38,

47877 Willich-Muenchheide II, Germany.

Tel. +49 2154 9206 0, Fax +49 2154 9206 4903

Keyboard Assembly

Position the holes at the bottom of the Keyboard against the holes in the side panel brackets.

Use four screws

{6}

to fasten the Keyboard.

Insert the pedal cable connector into the pedal jack located at the rear of the Keyboard.

Be sure that the connector is inserted in the correct orientation. Make sure that the cable clamp fastens to the pedal

cable.

Rotate the pedal adjuster until it comes in firm contact with the floor surface. If the adjuster is not in firm contact with

the floor,the pedal will wobble and cause malfunctions.

Headphone Hanger Assembly

Use two screws

{9}

to fasten the Headphone Hanger [10] to

the underside of the Keyboard.

Pedal

Cable Jack

Headphones

Jack

Pedal adjuster

Screws to fasten

the keyboard with

side panel