GarrettCom Magnum 20X Manuel D’Utilisation

Module (RPM) to provide either 10BASE2, 10BASE5, 10BASE-FL, FOIRL, or 10BASE-T 

connectivity.  The individual RPMs are used for one Ethernet segment each, and provide full 

IEEE 802.3 repeater functionality supporting a full length segment.  Individual RPMs are 

equipped  

with a single media interface 

connector. Any RPM can be 

installed in either slot of the 

Magnum 200X chassis.  

 

 

 

 

 

 

 

 

Figure 2.2.1:  Magnum 200X  

 

To simplify media connections, each media interface port is accessible from the 

front of the unit.  All LEDs common to the 200X unit and all individual port LEDs are 

front-mounted. No rear access is required except for the AC power cord. 

 

 

The internal power supply is auto-ranging to handle any AC power type 

worldwide. Power input may range from 90 to 260 vac, with a frequency rating of 47 to 63 

Hz.  The unit is equipped with a rear mounted IEC-type recessed male AC power 

connector.  (When shipped for use in areas other than 115 vac, a power cord will not be 

included).  The 200X unit is convection-cooled for silent operation. 

 

The Magnum 200X base unit features Power (PWR), Receive (RX), Collision 

(COL), and Jabber (JAB) LED status indicators located in the front of the unit.  These 

LEDs provide a visual assessment of the operational condition and aggregate network 

activity at the unit, and are in addition to the LEDs on each individual RPM. 

 

 

For standard 200X models, there is an option of four different Repeater Port 

eu

PWR  RX  COL  JAB