Brother XL-2230 Mode D’Emploi
KNOWING YOUR SEWING MACHINE —————————————————————————————————————————
8
THE MAIN PARTS
1 Bobbin winder (Page 18)
This winds the thread onto the bobbin,which you use
for the lower thread.
for the lower thread.
2 Spool pin (Page 18, 23)
3 Hole for vertical spool pin (Page 27)
3 Hole for vertical spool pin (Page 27)
This holds a second spool of thread, if you want to sew
with two needles.
with two needles.
4 Upper tension-control dial (Page 28)
This controls the tension of the upper thread.
5 Needle threader (Page 24)
This is only available on certain models.
6 Flat bed attachment with accessory compartment
(Page 14, 17)
7 Zigzag presser foot (Page 8, 13)
8 Pattern selection dial (Page 15)
8 Pattern selection dial (Page 15)
You can turn this in either direction to choose the stitch
you want.
you want.
9 Reverse-sewing lever (Page 17)
You can push this to stitch in the reverse direction.
0 Buttonhole fine-adjustment screw (Page 34, 41)
A Balance wheel
B Main power and sewing light switch (Page 11)
A Balance wheel
B Main power and sewing light switch (Page 11)
You can turn the main power and sewing light switch
on and off.
on and off.
C Foot controller jack (Page 10)
Plug in the foot controller plug and connect the
machine to the power supply.
machine to the power supply.
D Presser foot lever (Page 23)
E Foot controller (Page 11)
E Foot controller (Page 11)
You can use this to control the sewing speed, and to
start and stop sewing.
start and stop sewing.
Parts Code for Zigzag Presser Foot: XC4901-051
Foot Controller: Model N
Parts Code: XC5458-021 (110/120V Area)
Parts Code: XC5458-021 (110/120V Area)
XC5454-021 (220/240V Area)
XC5462-021 (U.K.)
XC5493-021 (Australia, New Zealand)
XC5494-021 (Argentina)
XC5495-021 (110/220V Dual Area)
XC5462-021 (U.K.)
XC5493-021 (Australia, New Zealand)
XC5494-021 (Argentina)
XC5495-021 (110/220V Dual Area)
4
2
1
9
3
8
7
5
6
0
A
B
C
D
E