Brocade Communications Systems 300 Manuel D’Utilisation
EZSwitchSetup Administrator’s Guide
3
53-1002157-01
Supported switches
1
FIGURE 2
Configuring Internet Explorer
Supported switches
You can use EZSwitchSetup with the switches listed in
Your switch must meet the following requirements:
•
It must be connected to an Ethernet LAN that is accessible by the host. If it is not, the system
issues the message “Page not Found.”
issues the message “Page not Found.”
•
It must have licensed FC ports. If the switch has no licensed FC ports, you must first install a
POD license and then enable the affected ports. For more information, refer to the section
POD license and then enable the affected ports. For more information, refer to the section
•
It must be in a single-switch fabric. If your switch connects to another switch (if there is an
E_Port on the switch), you cannot manage the switch using EZSwitchSetup until you
disconnect the switch connection.
E_Port on the switch), you cannot manage the switch using EZSwitchSetup until you
disconnect the switch connection.
NOTE
If there is an E_Port on the switch and if there is a zone conflict, then the fabric is segmented;
in this case, the switch is in a fabric by itself and EZSwitchSetup treats it as a single-switch
fabric.
in this case, the switch is in a fabric by itself and EZSwitchSetup treats it as a single-switch
fabric.
You cannot use EZSwitchSetup to manage a switch that has any of the following features enabled:
•
Virtual Fabrics with non-default logical switches
•
Access Gateway
•
User-defined Admin Domains
Configure your browser to
check for newer versions of
stored pages on every visit to
the page.
check for newer versions of
stored pages on every visit to
the page.