Bowflex TreadClimber TC1000 Manuel D’Utilisation

Bowflex

TreadClimber

Owner’s Manual

Assembly Guide

Step 2: CONNECTING SPEED PICkUP WIRE

Locate the following for this step:

PARTS:

• TreadClimber

Base & Treadle Assembly from

Step 1.

2-1 Connect the speed pickup wire from base

assembly and left rear roller casting

(see Figure 2-1 & 2-2).

NOTE: Speed pickup needs to be about 1/8"

from the pulley and the red speed

pickup cap is flush to the left drive

bracket/roller casting.

Figure 2-1

Speed pickup

wire from base.

Speed pickup

wire from left rear

roller casting.

Figure 2-2

Figure 3-2

Figure 3-3

Figure 3-1

Step 3: ATTACHING TEETER

Locate the following for this step:

PARTS:

• TreadClimber

Base & Treadle Assembly from

Step 2.

HARDWARE:

• One (1) 3/8” x 3-3/4” Shoulder Bolt

• One (1) 5/16” Nylock Nut

TOOLS:

• 3/16” Hex Key (included)

• 9/16” Open End Wrench (included)

• Scissors or other cutting tool

3-1 Carefully set unit up on its right side. This will have

the pulley side up and expose underneath side of

unit (see Figure 3-1).

3-2 Using the 3/8" x 3-3/4" shoulder bolt and 5/16"

nylock nut attach the teeter assembly to base

frame (see Figure 3-2). Tighten using the 3/16"

hex key and 9/16" open end wrench

(see Figure 3-3).

3-3 Cut wire tie from teeter stop brackets.

NOTE: Manipulation of the teeter and or

treadles may need to occur to line

up all the holes.