Manualsbrain.com
  1. Manuels
  2. Marques
  3. Boss Audio Systems
  4. GT-10B
  5. Manuel D’Utilisation

Boss Audio Systems GT-10B Manuel D’Utilisation

Télécharger
Page de 156
 
138
Chapter 8 Parameters Guide
Display of Parameters You Can Set with 
SYS KNOB SETTING
 
The parameter names displayed in the Play screen (p. 25) are 
abbreviated. For details about the parameter names, refer to 
the chart shown below.
 
EXP PEDAL SW SETTNG (Expression Pedal Switch 
Setting)
CTL1–4 PEDAL SETTING (CTL1–4 Pedal Setting)
Prefernc (Preference)
 
Patch
The patch pedal setting is used. This allows 
you to use different pedal settings in each 
individual patch.
System
The CONTROLLER screen’s pedal setting 
(Function, Min, Max and Src Mode) is used. 
This applies the same pedal settings to all 
patches.
 
Function
 
Off
The function is not assign to the pedals.
Ch. A/B
Switches between effect channel A and B.
Comp
Switches the COMP on and off.
OD/DS
Switches the OD/DS on and off.
Preamp
Switches the PREAMP/SPEAKER on and 
off.
EQ
Switches the EQ on and off.
FX-1
Switches the FX-1 on and off.
FX-2
Switches the FX-2 on and off.
Delay
Switches the DELAY on and off.
Chorus
Switches the CHORUS on and off.
Reverb
Switches the REVERB on and off.
Pedal FX
Switches the PEDAL FX on and off.
Send/Return
Switches the SEND/RETURN on and off.
Amp Ctl
Switches the Amp Control on and off.
Tuner
Switches the TUNER on and off.
Manual
Switches the MANUAL MODE on and off.
PL
Switches the PHRASE LOOP on and off.
PL Rec/Play
Records/plays back the phrase.
PL Clear
Clears the phrase.
PL Mute/Ply
Mutes playback of the phrase.
BPM Tap
Used for tap input of the Master BPM.
Delay Tap
Used for tap input of the delay time.
MIDI Start
Controls the Start/Stop of external MIDI 
devices (such as sequencers).
MMC Play
Controls the Play/Stop of external MIDI 
devices (such as hard disk recorders).
Lev +10
Increases the patch volume level by 10 
units.
Lev +20
Increases the patch volume level by 20 
units.
Lev -10
Decreases the patch volume level by 10 
units.
Lev -20
Decreases the patch volume level by 20 
units.
Num Inc
Switches to the next higher patch number 
in the same bank as the currently selected 
patch.
Num Dec
Switches to the next lower patch number in 
the same bank as the currently selected 
patch.
Bank Inc
Switches to the next higher bank number.
Bank Dec
Switches to the next lower bank number.
 
Parameter/
Range
Explanation
 
Min (Minimum)
 
Off, On
This sets the value for times when the 
switch is Off.
 
Max (Maximum)
 
Off, On
This sets the value for times when the 
switch is On.
 
Src Mode (Source Mode)
 
This sets the behavior of the value each time the switch is operation.
Moment
The normal state is Off (minimum value), 
with the switch On (maximum value) only 
while the footswitch is depressed.
Toggle
The setting is toggled On (maximum value) 
or Off (minimum value) with each press of 
the footswitch.
 
Display with SYS 
KNOB SETTING
Display at Play 
screen 1
Display at the 
bottom of the 
Play screen
 
COMP:CS:Sus
COMP CS SUS
CS SUS
COMP:CS:Atk  
COMP CS ATK
CS ATK
COMP:LM:Thres
COMP LM THR
LM THR
COMP:LM:Rel 
COMP LM REL
LM REL
COMP:MB:LoThr
COMP MB LTH
MB LTH
COMP:MB:HiThr
COMP MB HTH
MB HTH
COMP:NA:Drive
COMP NA DRV
NA DRV
COMP:Tone
COMP TONE
CS TNE
COMP:Level
COMP LEVEL
CS LEV
ODDS:Drive   
ODDS DRIVE
OD DRV
ODDS:Tone    
ODDS TONE
OD TNE
ODDS:EfectLev
ODDS E LEV
OD ELV
PRE:Gain
PRE GAIN
PreGAN
PRE:Level
PRE LEVEL
PreLEV
PRE:Bass   
PRE BASS
PreBAS
PRE:Mid    
PRE MID
PreMID
PRE:Treble 
PRE TREBL
PreTRB
PRE:Presnce
PRE PRES
PrePRS
PRE:Mic Lev
PRE M LEV
PreMLV
EQ:Low Cut   
EQ L CUT
EQ LC
EQ:Low Gain 
EQ LOW
EQ LOW
EQ:Lo-MidGain
EQ L MID
EQ LMD
EQ:Hi-MidGain
EQ H MID
EQ HMD
EQ:High Gain 
EQ HIGH
EQ HI
EQ:High Cut 
EQ H CUT
EQ HC
DELAY:Time   
DELAY TIME
DD TIM
DELAY:Feedbak
DELAY FBK
DD FBK
DELAY:Hi Cut 
DELAY H CUT
DD HC
DELAY:EfctLev
DELAY E LEV
DD ELV
 
Parameter/
Range
Explanation
GT-10B_e.book 138 ページ ２００８年２月２６日　火曜日　午後３時３０分