Whirlpool TGP325E Manuel D’Utilisation
11
E
G
HO
TT
ER
COOLER
E
G
1 NOTCH = 5˚F
Although your new oven is properly adjusted to
provide accurate temperatures, it may cook faster
or slower than your old oven.
provide accurate temperatures, it may cook faster
or slower than your old oven.
If you are not satisfied with the baking/roasting
results, you can change the temperature calibration
by following the steps below.
by following the steps below.
NOTE: DO NOT measure the oven temperature with
a thermometer. Opening the oven door will lower the
oven temperature and give you an incorrect reading.
Also, the thermometer temperature reading will
change as your oven cycles.
a thermometer. Opening the oven door will lower the
oven temperature and give you an incorrect reading.
Also, the thermometer temperature reading will
change as your oven cycles.
1.
Make sure the oven temperature control knob is
turned to the off position. Pull the knob straight
off and flip it over.
turned to the off position. Pull the knob straight
off and flip it over.
2.
Loosen the locking screws inside the
control knob.
control knob.
Note the position of the notches.
3.
Adjust the temperature.
•
To lower the temperature, hold the knob
handle firmly and turn the skirt counterclock-
wise to move the tooth a notch to the “G” on
the “COOLER” arrow.
wise to move the tooth a notch to the “G” on
the “COOLER” arrow.
•
To raise the temperature, hold the knob
handle firmly and turn the skirt clockwise to
move the tooth a notch to the “G” on the
“HOTTER” arrow.
move the tooth a notch to the “G” on the
“HOTTER” arrow.
Each notch equals about 5°F.
4.
Tighten the locking screws and
replace the control knob.
replace the control knob.
A
DJUSTING
THE
OVEN
TEMPERATURE
CONTROL
USING YOUR RANGE
E
G
HO
TT
ER
COOLER
E
G
1 NOTCH = 5˚F
Locking
screws
screws
Notches
Locking
screws
screws
E
E
G
G
HO
TT
ER
COOLER
1 NOTCH = 5˚F
Skirt
Tooth
Notches
To lower
To raise