Whirlpool 9753051 Manuel D’Utilisation
34
TROUBLESHOOTING
PROBLEM
The display is showing
“PF”
“PF”
“F-” followed by a
number shows on
the display
number shows on
the display
CAUSE/SOLUTION
•
There has been a power failure. Press OFF to clear the display, then reset
the clock. (See page 11.)
•
Press OFF to clear the display. If an “F” code appears again, call for
service.
service.
PROBLEM
CAUSE/SOLUTION
Cookware not level
on cooktop
on cooktop
•
Level the range. (See the Installation Instructions.)
•
Use cookware with a flat bottom.
Excessive heat on cooktop
in areas around cookware
in areas around cookware
•
Choose cookware the same size or slightly larger than the burner flame.
The oven temperature
seems too low or too high
seems too low or too high
•
Adjust the oven temperature control. (See “Adjusting the oven temperature
control” section.)
(Check to see if liquids
are level in cookware)
are level in cookware)
Slow baking or roasting
•
Preheat oven to selected temperature before placing food in oven.
•
Choose bakeware that will allow 2 inches (5 cm) of air space around
•
Position rack higher in oven.
•
Decrease oven temperature 15
°
to 25
°
F (8
°
to 14
°
C).
•
Increase baking or roasting time.
•
Increase temperature 25
°
F (14
°
C).
•
Preheat oven to selected temperature before placing food in when
preheating is recommended.
•
Choose bakeware that will allow 2 inches (5 cm) of air space around
•
Open oven door to check food when timer signals shortest time suggested
in recipe.
•
Oven peeking can make cooking times longer.
•
Level the range.
•
Bake in center of oven with 2 inches (5 cm) of space around each pan.
•
Check to make sure batter is level in pan.
•
Shield edge with foil.
Baked items too brown
on bottom
on bottom
Unevenly baked items
Crust edge browns
before pie is done
before pie is done
all sides.
all sides.
D
ISPLAY MESSAGES
C
OOKING RESULTS