Weber PLATINUM 3400 Series Natural Gas Barbecue Manuel D’Utilisation

Install bottom accessory trays

You will need: two accessory trays

Set the two accessory trays between the two frame
connectors. Figure 21.

Install igniter

Note - The igniter wires are already attached to the Gas
Catcher Ignition Chamber and the igniter. This was
done to factory test the ignition system.

The igniter lock nut and igniter gasket are on the igniter. 

Route the igniter and wires as shown. Figure 22 (a).
Insert the top of the igniter up through the large part of
the keyhole in the frame brace. Loosen the igniter lock
nut and slide the igniter to the rear of the keyhole with
the igniter gasket on top of the frame brace. Tighten the
igniter lock nut. Figure 22.

Note - If the igniter works loose, carefully tighten the
igniter lock nut with an adjustable wrench or pliers.

Igniter
lock nut

Keyhole in
frame brace

Frame brace

Small part of keyhole
in frame brace