Brother PS-300B Manuel Du Propriétaire

BAS-311E.311EL.326E.326EL

1. Remove the needle and presser foot.
2. Remove the flat screws 

w and screws r of the work

clamp guide brackets A 

q, B e and replace the work

clamp 

y with the H-position standard plate t.

Note: Attach the H-position standard plate 

t using the

work clamp guide brackets A 

q, B e and the flat

screws 

w.

3. Press the P key and adjust the X-sensor setting plate 

i so that the needle u is aligned with the home position (X=0,

Y=0) of the H-position standard plate 

t.

4. Press the P key again to make sure that the needle 

u is aligned with the home position (X=0, Y=0) of the H-position

standard plate 

t.

5. Secure the X-sensor setting plate 

i using the screws o.

6. Remove the needle 

u.

7. Press the P key to be out of the program mode, and turn off the power.
8. Replace the H-position standard plate 

t with the work clamp.

Note: When adjusting the X home position, be sure to set the clearance between the X-home position dog 

!0 and the

surface where the sensor 

!1 is activated to 0.1 - 0.5 mm.  If the clearance is too great, an error in home position

detection may occur because the temperature of the sewing machine rises during sewing operation.

■ (X axis)

q

r

w

e

t

y

!1

!0

i

o

0.1 - 0.5mm

y

u

H - position
(X = 0, Y = 0)