Worth Data 802 RF Manuel D’Utilisation
1-5
Upon power-up, the R/F Terminal displays the following opening screen:
802 TERMINAL 1XWFUnnn
ServerIP=nnn.nnn.nnn.nnn
DeviceIP=nnn.nnn.nnn.nnn
Ch:=n SSID=xxxxxxxxxxxx
WEP=128 Rnn
HIT ANY KEY
ServerIP=nnn.nnn.nnn.nnn
DeviceIP=nnn.nnn.nnn.nnn
Ch:=n SSID=xxxxxxxxxxxx
WEP=128 Rnn
HIT ANY KEY
(The opening screen can be bypassed upon power up. See Chapter 2)
•
The first line on the screen,
802 TERMINAL WFUnnn,
gives the
firmware revision number.
•
Server IP
either shows the Server's fixed TCPIP address; or if
Device searches out the Server, shows 0.0.0.0.
•
Device IP
either shows the Device's fixed TCPIP address or if it
is determined by a DHCP Server, shows 0.0.0.0.
•
Ch:=nn
shows the
channel to start using, (the channel of the most
frequently used Access Point, 01-11).
•
SSID=xxxxxxxxxxxx
refers to the first 12 characters of the up
32 ch character network
name.
•
WEP=128 or 64 or NO
shows how the Device is configured
with an encryption key.
•
Rnn=
the radio firmware
version.
To move on to the first menu item, press any key on the R/F Terminal keypad.
The display now reads:
DEVICE SIGN ON ----->1
SETUP MODE----------->2
SITE SURVEY----------->3
SETUP MODE----------->2
SITE SURVEY----------->3
•
Press the
1 key to initiate to a two-way communication host
computer program through an Access Point.
•
Press
the 2 key to change the configuration of the Terminal Device.
•
Press the
3 key to survey the intended site for adequate coverage.
This screen can be skipped (see
Chapter 2; RF System Setup), causing the R/F
Terminal to automatically enter
DEVICE SIGN ON at power up.