Western Digital My Book World Edition II(white light) Manuel D’Utilisation
TROUBLESHOOTING - 174
MY BOOK WORLD EDITION
USER MANUAL
To reset the system to factory default settings:
Performing a factory default reset using the Network Storage Manager erases all
settings, shares, and data files in the My Book World Edition. All information and data
is lost. For detailed instructions, see “To restore the device to factory defaults:” on
page 112.
settings, shares, and data files in the My Book World Edition. All information and data
is lost. For detailed instructions, see “To restore the device to factory defaults:” on
page 112.
Hardware Diagnostic Testing
This section provides a detailed approach to identifying a hardware problem and
locating its source.
locating its source.
WARNING! Before disconnecting any peripheral cables from the system,
turn off the My Book World Edition and any external peripheral devices.
Failure to do so can cause permanent damage to the My Book World
Edition and/or the peripheral devices.
turn off the My Book World Edition and any external peripheral devices.
Failure to do so can cause permanent damage to the My Book World
Edition and/or the peripheral devices.
1. Turn off the My Book World Edition and all external peripheral devices.
2. Make sure the power cord is plugged into a properly grounded AC outlet.
3. Turn on the device. If the power indicator on the front panel does not light, see
“LEDs do not light up.” on page 174.
Specific Problems and Corrective Actions
The following contains specific problems that may arise during the use of the My
Book World Edition. Possible solutions are listed for each problem.
Book World Edition. Possible solutions are listed for each problem.
LEDs do not light up.
Do the following:
•
Make sure the power button on the rear of the device is turned on.
•
Make sure the power cord is connected correctly.
•
Make sure that the wall outlet has power. Test it by plugging in another device.
System cannot connect to a network and network status indicator does not light.
•
Make sure the network cable is securely attached to the correct connector on the
rear panel of the device.
rear panel of the device.
•
Try a different network cable.
•
Make sure the network switch or router has power.
•
Check the cabling and network equipment to make sure that all cables are
properly connected.
properly connected.
•
Try another port on the switch.
Network Storage Manager does not appear when I click Configure in WD Discovery.
Make sure JavaScript is enabled in your browser. See your browser’s Help menu for
instructions.
instructions.