Spectrum Brands MI.20xx Manuel D’Utilisation
60
MI.20xx Manual
External TTL trigger
Trigger modes and appendant registers
Positive and negative TTL trigger
This mode is for detecting the rising and falling edges of an ex-
ternal TTL signal. The board will trigger on the first rising or falling
edge that is detected after starting the board. The next triggere-
vent will then be detected, if the actual recording/replay has fi-
nished and the board is armed and waiting for a trigger again.
ternal TTL signal. The board will trigger on the first rising or falling
edge that is detected after starting the board. The next triggere-
vent will then be detected, if the actual recording/replay has fi-
nished and the board is armed and waiting for a trigger again.
Pulsewidth triggers
TTL pulsewidth trigger for long HIGH pulses
This mode is for detecting HIGH pulses of an external TTL signal
that are longer than a programmed pulsewidth. If the pulse is
shorter than the programmed pulsewidth, no trigger will be detec-
ted. The board will trigger on the first pulse matching the trigger
condition after starting the board. The next triggerevent will then
be detected, if the actual recording/replay has finished and the
board is armed and waiting for a trigger again.
that are longer than a programmed pulsewidth. If the pulse is
shorter than the programmed pulsewidth, no trigger will be detec-
ted. The board will trigger on the first pulse matching the trigger
condition after starting the board. The next triggerevent will then
be detected, if the actual recording/replay has finished and the
board is armed and waiting for a trigger again.
TTL pulsewidth trigger for short HIGH pulses
This mode is for detecting HIGH pulses of an external TTL signal
that are shorter than a programmed pulsewidth. If the pulse is lon-
ger than the programmed pulsewidth, no trigger will be detected.
The board will trigger on the first pulse matching the trigger con-
dition after starting the board. The next triggerevent will then be
detected, if the actual recording/replay has finished and the
board is armed and waiting for a trigger again.
that are shorter than a programmed pulsewidth. If the pulse is lon-
ger than the programmed pulsewidth, no trigger will be detected.
The board will trigger on the first pulse matching the trigger con-
dition after starting the board. The next triggerevent will then be
detected, if the actual recording/replay has finished and the
board is armed and waiting for a trigger again.
Register
Value
Direction
Description
SPC_TRIGGERMODE
40000
r/w
Sets the triggermode for the board.
TM_TTLBOTH
20030
Sets the trigger mode for external TTL trigger to detect positive and negative edges.
Register
Value
Direction
Description
SPC_PULSEWIDTH
44000
r/w
Sets the pulsewidth in samples. Values from 2 to 255 are allowed.
SPC_TRIGGERMODE
40000
r/w
Sets the triggermode for the board.
TM_TTLHIGH_LP
20001
Sets the trigger mode for external TTL trigger to detect HIGH pulses that are longer than a programmed pulsewidth.
Register
Value
Direction
Description
SPC_PULSEWIDTH
44000
r/w
Sets the pulsewidth in samples. Values from 2 to 255 are allowed.
SPC_TRIGGERMODE
40000
r/w
Sets the triggermode for the board.
TM_TTLHIGH_SP
20002
Sets the trigger mode for external TTL trigger to detect HIGH pulses that are shorter than a programmed pulsewidth.