Raymarine Radar Scanner Manuel Du Propriétaire
Chapter 2: Installing the Scanner
37
Display unit connection
CAUTION:
Do not use an open array scanner with an SL70 or Autohelm 7"
LCD display unit. Failure to observe this may result in
permanent damage to the display unit.
10 kW open array scanners cannot be directly connected to 12 V
systems.
Do not use an open array scanner with an SL70 or Autohelm 7"
LCD display unit. Failure to observe this may result in
permanent damage to the display unit.
10 kW open array scanners cannot be directly connected to 12 V
systems.
The rear of the Pathfinder display includes the following connection
sockets:
sockets:
•
Scanner connection
•
Power/NMEA Input DC power connection, two NMEA 0183
inputs and one RF ground (screen) connection.
inputs and one RF ground (screen) connection.
Note: If you have an integrated system that includes a radar display
with MARPA as a primary function, the scanner must be connected to
this display to enable the function. MARPA is then available on any
repeater display.
with MARPA as a primary function, the scanner must be connected to
this display to enable the function. MARPA is then available on any
repeater display.
Connect the scanner cable to the scanner connector and power to the
power/NMEA input connector.
Power and all other connector details are supplied in the display unit
Owner’s Handbook.
power/NMEA input connector.
Power and all other connector details are supplied in the display unit
Owner’s Handbook.
POWER/
NMEA
ANTENNA/
TRANSDUCER
NMEA
SeaTalk
DISPLAY
FUSE
HSB
LCD Display
CRT Display
D4597-2
Power and NMEA Input
Scanner
Connector Panels
154_4.book Page 37 Wednesday, October 25, 2000 3:02 PM