Raritan Engineering Command Center CC-SG Manuel D’Utilisation
C
HAPTER
5:
ADDING DEVICES AND DEVICE
G
ROUPS
53
Figure 56 Add Device Screen for IPMI Server (v 1.5)
Figure 57 Add Device Screen for Generic Device
5. Type the new device name in the Device name field.
6. Type the IP Address or Hostname of the new device in the Device IP or Hostname field. For
6. Type the IP Address or Hostname of the new device in the Device IP or Hostname field. For
7. The TCP/UDP port number value will be populated automatically based on the device type.
For example, the default UDP port for an IPMI device is 623.
8. Type a description (or location) of the new device in the Description field.
9. Type the name used to log onto this device in the Username field.
10. Type the password needed to access this device in the Password field.
11. If applicable, type the time (in seconds) that should elapse before timeout between the new
9. Type the name used to log onto this device in the Username field.
10. Type the password needed to access this device in the Password field.
11. If applicable, type the time (in seconds) that should elapse before timeout between the new
device and CC-SG in the Heartbeat timeout (sec) field.
12. For IPMI Servers, enter an Interval that is used to check for availability and an
Authentication Method, which needs to match what has been configured on the IPMI Server.
Note: You will not see a TCP port number or Heartbeat timeout field for HP iLO/RILOE devices,
older Dominion SX units (version 2.4 or earlier), IPMI Servers, and Generic devices.
older Dominion SX units (version 2.4 or earlier), IPMI Servers, and Generic devices.
13. Click OK to add the device or Cancel to exit without saving.
14. For Raritan devices, if the firmware version of the device is not compatible with CC-SG, a
14. For Raritan devices, if the firmware version of the device is not compatible with CC-SG, a
message will alert you and ask if you want to proceed (please see Chapter 2: Accessing CC-
SG for additional information). Click Yes to add the device to CC-SG, or No to cancel the
operation. You can easily upgrade the device firmware after adding it to CC-SG (see section
Upgrade Device later in this chapter).
SG for additional information). Click Yes to add the device to CC-SG, or No to cancel the
operation. You can easily upgrade the device firmware after adding it to CC-SG (see section
Upgrade Device later in this chapter).
15. A Device Created Successfully message confirms that device has been added.
16. Repeat steps 1 through 12 to add other devices.
16. Repeat steps 1 through 12 to add other devices.