Yorkville M608 YS 1088 Manuel D’Utilisation

MICROMIX

Tip: Alternatively, this signal at this jack can be connected to the input of an exter-

nal stereo effects unit and returned via channel 5/6 or 7/8 However, if you do not

require any effects at all, the effects bus output signal can be connected to the

input of an additional monitor system or another amp/speaker system via the EFX

Out/Footswitch jack using a standard balanced patch cord. In this case, the EFX

controls would act as send controls to achieve a semi-separate mix. Remember

that the channel LEVEL controls also affect this signal.

6. Channel Pan and Bal Controls

The signal balance of each channel going to the left and right main PA channels can be

adjusted by the

Pan control in channels 1 to 4, and by the Bal control in channels 5/6

and 7/8. Turning this control counterclockwise towards the

L will increase the signal level

in the left channel to a maximum of 3 dB while also reducing the level in the right chan-

nel to zero. Turning the control clockwise towards the

R will increase the signal level in

the right channel while also reducing the signal level in the left channel.

Master Section

1. MAIN Master Control

The

MAIN master control adjusts the overall level of the main

mix, the PA volume.

Note: To ensure maximum signal headroom and clarity, set

the channel LEVEL controls first for a good signal without

clipping, then set the master for the overall volume desired.

2. MON Master Control

The overall level of the monitor mix is adjusted with the

MON

master control.

Note: As with the MAIN master, set the MON

master to deliver the desired volume after set-

ting the channel sends.

3. MAIN EFFECTS Return Control

The

MAIN EFX control regulates the amount of signal going

from the output of the internal Digital Effects Processor to

the

MAIN mixing bus where it is mixed with the dry signals

directly. It controls the intensity of the effects on the left

and right

MAIN output signals.

4. MON EFFECTS Return Control

The

MON EFX control regulates the amount of signal going

from the output of the internal Digital Effects Processor to

the

MON mixing bus where it is mixed with the dry signals

directly from the channel

MON send controls. It controls the

overall effects intensity for the

MON Out signal.

5. Post-EQ OUT

These jacks offer a variety of patching and routing options. They are positioned in the

signal path after the

M608 main graphic equalizers.

These bus signals are at line level, not speaker level (use the

SPEAKER outputs on

the rear panel to drive speakers). Using signals from these jacks has no effect on the

operation of the

M608's built-in power amplifier. This makes it possible to feed an

external power amplifier, or even multiple inter-connected power amps, while the inter-

nal power amplifier is functioning.

Note: It is not necessary to have speakers connected if you’d like to use the unit

strictly as a mixer. If a mono signal is required, possibly to feed a mono-house PA or

another amp/speaker system, use the L/Mono Post-EQ jack. Mono operation of this

jack is switched to left channel only as soon as a jack is inserted in the L Post-EQ

jack. They follow the operation of the Main/Mon switch described below.

MON EFX Rtn

MAIN EFX Rtn

Post-EQ

MAIN OUT

Post-EQ

MON OUT